Your cart is empty.
Your cart is empty.Three flute design allows these bits to provide the best finish on your project. Up cut spiral design provides the best control with hand or table routing. When creating dado's this design brings chips up and out of the cut.
Craig Tarte
Reviewed in the United States on April 3, 2024
This carbide bit is 100x better than any HSS bit. I'm very impressed with this bit. It cuts right through any hardwood. Would definitely buy from this manufacturer again.
Jim Garrison
Reviewed in the United States on September 14, 2020
Gives very clean cuts...beautiful bit.
Allan Grant
Reviewed in the United States on August 3, 2020
Whiteside’s bit performed as expected...perfectly. I’m building a large table for a sanctuary and needed a number of mortises for the tenons to give the base the strength required to hold the eventual top. It plunged smoothly and cut cleanly. I couldn’t ask for more. I highly recommend the bit.
MrBill
Reviewed in the United States on December 21, 2019
Would love to give SIX stars. These Whiteside bits are just perfect for making tenons on a router table. From now on I'll keep an eye out for similar bits made of solid carbide, and having more than two flutes. Perfection! To make these bits even more interesting, they're manufactured in the USA, in North Carolina!!
Drastic
Reviewed in the United States on October 25, 2019
Whiteside router bits generally cannot be bettered by any manufacturer. This one in particular produces the cleanest, smoothest, quietest and most effortless cuts without chipping on the outfeed side. Highly recommended.
Noli Del Rosario
Reviewed in the United States on September 10, 2014
Works great on my Porter Cable 7518 mounted on INCRA's PRL-V2 supported on Woodtek Cast iron table. Very stable, perfect cut everytime.
Peter K.
Reviewed in the United States on July 26, 2014
I was very impressed with how cleanly it cut the curly maple I was working with. It saved me heaps of time sanding the edge grain.
James Clark
Reviewed in the United States on December 25, 2011
I am a woodworking hobbyist with many years and many projects behind me. I have tried many different manufactures over the years: Freud, Amana, Bosch .. and cheapies like Sears. While some of the better names do make very good bits, I found the Whiteside superior. Right out of the box they are very sharp, amount (size) of carbide is big (allows more sharpening cycles), the quality carbide means they stay sharper longer; no chatter and burn marks are very rare. Also unlike some bits the PN marking is easy to read. If they get mixed up (happens to me all the time despite my organized storage system) it is very easy to find the ¾ vs. the 23/32 straight bit. They may be a little more expensive but it is definitely worth it. If you haven't tried Whiteside I encourage you to try them and put it through its paces. You might not notice a difference against one of the other better brands right away, but over time I bet you too will be hooked.
Recommended Products
