Your cart is empty.
Your cart is empty.Product Description
X AUTOHAUX PCV Valve Grommet Kit 90° 17130-PK1-003 17130-PM6-003
Nathan Joly
Reviewed in the United States on September 9, 2021
Drilled a hole in my CAI, cut the end down and installed on my 2005 Silverado. Stopped oil consumption because of the internal block that makes it so the intake can't create a higher vacuum to drawn in oil. Perfect for anyone that did a TBSS/NNBS manifold swap that has a stock throttle as that CAI vacuum will be higher than stock or with a 90mm throttle.
Chapo
Reviewed in the United States on September 15, 2021
No sé ajusta el sello
braver
Reviewed in the United States on August 30, 2021
Doesn’t fit at all , was oversized grommet and undersized pcv. I Wouldn’t recommend it
Pam G
Reviewed in the United States on February 24, 2021
PCV Valve and grommet were in good condition, tests good, and fit, but isn't a good replacement for the original OEM part on my 01 Toyota Solara V6. I replaced my PCV and grommet because of grommet cracking and broke my old PCV trying to get it out. Put this one in and immediately I began to get an enormous amount of exhaust smoke. Thinking maybe old buildup, etc. I drove it about 300 miles, had major smoking issue all the way. and used a quart of oil. I replaced it with an genuine OEM Toyota PCV and grommet and smoking and oil consumption went away.
Kai Moua
Reviewed in the United States on May 16, 2020
It’s a little bigger then the stock pcv valve and the grommet that comes with it fit very good. 5 star.
Buyer 1000
Reviewed in the United States on November 15, 2020
Well, though my Amazon garage said this fit my 1995 Camry, the angle was different than the OEM, and I would need to go and buy different tubing to make it fit. The rubber gasket and the base were the correct dimensions, but it was not an exact fit due to the angle. Will probably try to return this part.
Recommended Products