Your cart is empty.
Your cart is empty. Applied to places such as offices, meeting rooms, auditoriums, music halls, etc
-Air vent is good for ventilating wardrobes, small acrylic vivariums
-Honeycomb design, dust-proof, anti foreign, not easy to plug.
Air vents are made of super-thick stainless steel.
Not easily deformed.
It is twice as thick as other products of the same type on the market.
karen
Reviewed in the United States on March 9, 2021
Thank you, quality product. Will purchase them again.
Romie808
Reviewed in the United States on April 21, 2021
Great, cheap and good buy
Samuel A. Brown
Reviewed in the United States on August 25, 2019
These soffit covers are essentially replacing the soft and failing wire mesh placed on Shea Homes built Condo Complex. Birds were destroying the corroded metal screen wire placed inside the 2x6 lumber on the interior attic side. These are going in the soffit holes on the outside and they slide in easily if the soffit holes were properly cut. About one half required me to cutout rough areas so the Mesh Hole Air vents would fit properly. I had to use a small hammer and rubber handled UG cable skinning knife to gently pound some pieces in flush. Some were dented slightly in the process.
Don P. Jones
Reviewed in the United States on August 1, 2019
Used for rafter vents. Had to open the holes up on the house. Vents are great quality and did the job.
Customer
Reviewed in the United States on July 23, 2019
I have a 60 yr old house w 2 inch vent holes around the roof line, 1 mile in from the ocean.The old wire grating orig placed in the attic over the holes is all but rusted out. These vents mostly fit in just as they came out of the bag,unless there was too much paint build up in the hole, at which point a light tap or 3 with a rubber mallet convinced them to slip in. 37 vent holes, took all of about 25 minutes to cap them all with these. Moving the ladder was the biggest time use
Kalani Nicholls
Reviewed in the United States on June 5, 2019
Used them for soffit vents because birds were establishing a full on neighborhood in my attic space. As others have said, they are a little too big to fit in as is. Instead of fussing with snipping and fitting each one into the existing hole, I just bought a 2" (51 mm) hole saw and hogged out each hole. IMHO, way easier, and now those kooky little tabs that hold this thing in place actually work. I used a Kobalt hole saw and it's still sharp after finishing the entire job. Since these things are pretty shallow, you don't have to cut all the way through anyway, just maybe an inch. If you are obsessive compulsive (like me), paint the holes before you stick the thing in. Oh and best of all, it's a 2 piece design so you can easily rotate the outer portion after install so the holes on each line up perfectly.
Alex Warner
Reviewed in the United States on May 10, 2019
These are in fact too large for a 2” hole. I did the same as the other reviewer and snipped the back of them to force them in. Not fun when I have 140 to install.
Daniel T. Benedict Jr.
Reviewed in the United States on March 24, 2019
Easy to install with utility knife and hammer. No adhesive needed. Great value in comparison to other products.
Recommended Products
