Your cart is empty.
Your cart is empty.Product Description
Acetylene Regulator CGA 510 Fitting for Torch Cutting Kits
YaeTek Welding gas welder acetylene Regulator for torch cutting kits CGA 510
You can use this acetylene regulator to replace the worn out regulator in your welding kit! It's a great acetylene regulator for any welders, which displays accurate pressure with 2-5/8 in. diameter gauges.
Inlet: 0-400 PSI
Outlet pressure: 0-30 PSI
2-5/8 in. diameter gauges
Inlet thread:CGA 510 female
Hose connector: 6mm;
Outlet Thread: 9/16;
work with harris or victor torch kit
Jeff
Reviewed in the United States on March 14, 2025
Works as advertised
judy
Reviewed in Canada on September 25, 2024
use for blowing glass with propane and another regulator for oxygen
joseph e.
Reviewed in the United States on December 24, 2024
Good tool
Chad Warner
Reviewed in the United States on November 4, 2023
No issues whatsoever.
Customer
Reviewed in the United States on October 27, 2023
Works great good price
Keith
Reviewed in the United States on March 13, 2022
for the price its unbeatable, has large clear and accurate gauges. My other regulators are now in need of rebuilding and I own Air- Gas, Victor and Harris regulators, just rebuilding one is almost the cost of this regulator. It had no leaks and the shipping was phenomenal, ordered and it arrived the next day. I am a welder and Electrician by trade and have done so for over 40 years, this regulator is just what someone stating on a budget needs, I plan on buying the oxygen regulator and going to check out what else they have to offer. Thank you for making a decent product.
William T. Sims
Reviewed in the United States on September 23, 2020
Just received my new acetylene regulator. It looks like it is built very well. Installed it on the tank and hoses. When I opened the tank valve, I smelled a leak. I removed the regulator and reinstalled it with yellow Teflon tape at both tank and hose connectors. Still smelled acetylene. Did the soapy water test at all connections points and on the regulator. No bubbles anywhere. Should I remove the pressure adjustment handle and put soapy water in that hole?Other comments: fast shipping to my location in Alaska. Any advice on possible leak in regulator?
M. Fellows
Reviewed in the United States on July 22, 2020
I replaced an old presto-lite regulator with a perforated diaphragm. Wasnt worried about the hose end becuase it had a barbed hose end. It runs from 1 to 14 psi its very smooth and vernier and worked hassle free on a large job. Regulator is used with a presto-lite fuel air torch set.
C. Carlson
Reviewed in the United States on October 12, 2020
My gas welding setup is 40 years old and the acetylene regulator developed a leak. Due to age, no repair parts are available so I purchased this regulator to finish some projects. It was quick to install and worked as well as the original regulator so I am very pleased with it. The brass construction is quite nice and I believe it will give good service over time with just normal care and maintenance.
Recommended Products
$89.00
$ 41 .99 $41.99