Your cart is empty.
Your cart is empty. Specs:
Model: JST XH 2.54 connector
Wire gauge: 22awg
Wire length: 10cm
Color: Red and Black
Material: Plastic, metal
Quantity: 10 pairs
Application:
It widely used in electrical appliances, automobiles, robots, lighting, toys, PCB control panel, speakers, audio, batteries, household appliances, etc.
Package List:
10pcs male JST XH with 22awg 10cm silicone cable
10pcs female JST XH with 22awg 10cm silicone cable
J D L
Reviewed in the United States on January 7, 2025
I used this instead of buying the ComfortBilt Pellet Stove thermostat connection wire. In order for this feature to work, your stove must already have the blue 4-wire data cable style electronics. (Cycle through your modes to see if your panel has the 'Thstat' mode available). Follow the manufactures instructions.
user
Reviewed in the United States on March 25, 2024
Well constructed with a slightly heavier 26 Guage wire as compared to other similar products. Polarity from male to female was correct. Worked great on my electrical project!
Kevclar
Reviewed in the United States on February 17, 2024
These use silicone covered wires and to avoid confusion they use the correct red/black polarity. Used to replace a potentiometer on an SCR voltage regulator circuit board.
DB-FROM-KC
Reviewed in the United States on January 9, 2024
When you plug the male and female pigtails into each other, they change your polarity. Going in is plus - minus, coming out is - Plus. Don't know what you would use that for
Hovey Corbin
Reviewed in the United States on April 24, 2024
I have a Dry Guy Turbo boot dryer that uses a small fan motors in the fan units to dry out my work boots. The bearings inside the fan motors in the dryer housings wear out and need to be replaced periodically. I am using these connectors on the power wires for the fan motors to enable me to quickly and easily swap out a failed fan motor. They are nice and small and will easily fit inside the Turbo dryer housing. They look to be of good quality and they should last me for a long time.
kevk
Reviewed in the United States on December 22, 2023
Of all of these type connectors that I have bought, and there have been many, these are the only sets that have the polarity, correct! I also like the fact that on the female connectors, there is reinforcement where the wires go into the housing. In other connectors, the wire always seems to break where it goes into the housing. Buying more to replace the ones that I have previously purchased from other vendors.
Jeremy Smith
Reviewed in Canada on January 26, 2023
Grabbed these to add two fans and extend the length of another. Nicely pre-tinned and has some good quality silicone.
David Broido
Reviewed in the United States on April 14, 2023
They work as they should!
jh
Reviewed in the United States on November 6, 2022
Twisted wire count for conductors is spot on for these connector pairs, good quality insulation handles high heat (not like PVC). Used to replace undersized connectors on Lipo battery packs (custom). Fit the TRAX charging system. Would purchase again.
Doc Adam
Reviewed in Canada on November 15, 2022
I am using one of these to wire up a relay for an Arduino board to switch a 120 v water pump on and off. The connector works as advertised.
Recommended Products
