Your cart is empty.
Your cart is empty.
About the 12V10A DC Power Supply:
Input Voltage: 100~240V AC 50-60HZ
Output Voltage: 12V DC
Output Current: 1A/2A/3A/4A/5A/6A/7A/8A/9A/10A
Widely used in Industrial automation, LED display, communications, etc.
Input jack: Plug word article
Working Temperature: 0~40
Storage Temperature: -20~60
Ambient Humidity: 0~95% Non-Condensation
Efficiency:80%
Package:
1x 12V 10A power supply
1x AC power cord
1x DC female connector
Ed S
Reviewed in the United States on March 31, 2025
I have a couple of 5 meter WS2814 RGBW LED strips with 60 LEDs per meter that I'm installing on the house as holiday decorations. I needed a power supply big enough to drive all those LEDs.This 10 amp, 12 volt power supply is perfect for my application. It lights both strings beautifully, and it works as it should. My house will finally have the holiday lighting that I always wished it had. I'm happy with this power supply.
K. Jacobs
Reviewed in the United States on March 31, 2025
Simple project power adapter. It's a bit bigger than some of my smaller adapters, approx 2" x 6" x 1" for the brick. The power cord is nice and heavy duty and flexible. The included terminal block is great for project work. 10a is also a very healthy output for a 12V adapter. Tested it on my multimeter and saw a nice stable 12.46 volts out.
Jon Foster
Reviewed in the United States on March 24, 2025
This power supply will be used to run a Raspberry Pi5 NAS. I ran some basic tests on it and so far so good. Everything is as advertised. The supply is 12 volts and rated at 10 amps. My NAS when loaded up with all the drives and running under a full load shouldn't need more than 5 amps. I like to run electronics well below their maximum limits to extend their usable life and in general, keep the heat down to reasonable levels. Heat is a killer when it comes to electronics...As usual, I'll update the review if anything worthwhile happens.
Zaac
Reviewed in the United States on March 24, 2025
The media could not be loaded.
A. Devereux
Reviewed in the United States on April 9, 2025
I purchased this power supply to power a 16 ft of RGBW LED strips - it had no problem powering it! In fact, I was expecting the strip to be a little bit dim because they may require more than 10amps, it still covered the whole length well with minimal voltage drop!The unit itself did not get all that hot (compared to other, similar power supplies) and had no visible noise (another good sign). The lengths of the cords are pretty good as well - that tends to be a cost-cutting measure, but isn't here. The barrel to screw-down adapter is nice as well.Overall, I would recommend this to anyone looking to power some 12v LED strips!
CRAB
Reviewed in the United States on April 29, 2025
Used this to power a power seat from a Mercedes Benz for a sim racing rig. Works great and was one of the cheaper 10a versions. Appears to be well made and should last.
johnwd
Reviewed in the United States on April 2, 2025
Nice 120W power supply. Great that it comes with the cable stays and screw terminal adapter. Very happy with this unit.
Recommended Products
