Your cart is empty.
Your cart is empty.Product Description
2.5 Inch Butt Joint Exhaust Band Clamp Sleeve Stainless Steel
Specification:
Inside Diameter: 2.5 inch(64.1mm)
Overall Length: 3 inch(76.2mm)
Height: 3.66" (93mm)
Material: Stainless Steel
Installation: Bolt On
Universal fit for most 2.5 inch OD exhaust pipe
Join 2.5 inch OD pipe to 2.5 inch OD pipe
2.5 INCH BUTT JOINT BAND CLAMPS
Fitment: For 2.5” outside diameter pipes
No Welding :No welding design makes butt joint clamp fast, easy and accurate installation.
Easy Seal “Butt-Joint” Band Clamp:
- Butt joint clamps are also a good choice when cosmetic appearance is important.
- This type of clamp is for connecting two pipes that have the same outside diameter.
- This clamp comes disassembled and conforms to the pipe upon installation.
- Reaction block and forced bar for complete inner circle seal.
- This type of clamp does require that the sections being clamped have sufficient lengths of straight pipe leading into it.
- This clamp will not work properly if installed too closely to a bend.
WALSH
Reviewed in the United States on March 24, 2023
It's a nice clamp and provides an easy fix for what would likely cost 10x as much if taken to a shop.Tailpipe rusted through and broke right at the point where the pipe was expanded to fit over the rear muffler. It's three inch pipe but with the expansion it's closer to 3 3/16. This band clamp barely fit - granted it wasn't supposed to. Was able to squeeze the bolted section together with vice grips and then fit the bolts to get a couple threads started. From there, some judicious tightening got it sealed almost all the way up.
MKing
Reviewed in the United States on September 13, 2022
The aluminum piece between the clamp is absolute junk. They aren't machined properly so the clamp gets bent and ultimately would cause the pipes to get out of shape. Save your money and get them somewhere else.
JORGE
Reviewed in the United States on December 12, 2022
Looks awesome
Recommended Products
$27.80
$ 11 .99 $11.99