Your cart is empty.
Your cart is empty.Product Description
RGU
Reviewed in the United States on February 27, 2025
Good lightPlenty of wire for easy hook upLiked the soft color optionSmall problem the plastic cover that protect the leds and provides access takes a tremendous effort to push away from three retaining tabs. Needed two hands to push back and another person to slides a thin screw driver under to aid release. After install I never slide the plastic under the middle tab because I thought I might break the plastic. Lastly the supplied wire nuts are tiny. You'll undoubtedly need larger ones.
Customer
Reviewed in the United States on February 20, 2025
Easy to install lots of light would recommend.
Stephen
Reviewed in the United States on February 15, 2025
Great light,straightforward installation and super bright. Im happy with my purchase.
Jay
Reviewed in the United States on January 31, 2025
Swapped out 5-2' and 3-1' under cabinet fluorescent fixtures with these, instalation was smooth(took about 45 minutes), all needed parts were included, nice even bright light (a bit too bright, will be adding a dimmer switch) I'm extremely pleased with the product so far
RLH
Reviewed in the United States on April 3, 2025
perfect for under the counters
GregB
Reviewed in the United States on December 2, 2024
The color of the light is just right. The mfg could add more rubber grommets to protect the romex feeding it. Mounting it was a chore. Looks good after it’s done.
Tamara Earl
Reviewed in Canada on November 16, 2023
The BOLT for the "Cable Connector" did not fit the connector, that was with the unit. The light is more on the"Pinkish" side of colour, than warm.The installation was a challenge to put back together and have the wires tucked in neatly, but we got it done...
William S.
Reviewed in the United States on April 1, 2023
This LED lamp was the perfect addition to my condo which did not have any under cabinet lighting. I placed it dead center of the sink, whereu I had a small shelf and no cabinet of course), drilled 2 holes, bought a nice 3 wire black extension cord, hooked the light up and tucked the cord in neatly, securing it with wire staples from the hardware store. The light is PERFECT in the evening and at light to light up the kitchen counter and floor while not disturbing the living room connected to it. The overhead lights were too much, the microwave lights wayyyy too dim, this one is perfect and the correct Kelvin color for the evening. Not a blue white that I use overhead to cook and cut with. If your remotely handy this LED light is a quick install and priced right. I’m probably buying a couple more for my laundry area and other areas like a closet. The extension cord idea makes the light go where you need it, if you don’t permanently mount it. Plus no junction box work either. So add $10 to the price of it for the extension cord and wire staples. That will be your total expense. Built in switch is exactly what I needed also. I control it alone. Bright enough to do dishes and make a drink, but low enough to not disturb my movie nights. A+++
CarpCaster
Reviewed in the United States on November 6, 2018
Installed this 24" model. The light is 3,000 Kelvin. Nice brightness. There is an on/off switch as shown in the picture. Now that it's installed (for about two days) there isn't much more to say about the light. The light is slim enough to fit under the cabinets nicely although in my case, since it's mounted fairly far back, a thicker one probably would have worked fine.The big thing for me was the installation. Everything you need for is included; wire nuts, screws (didn't need); strain relief connector.The mounting holes were in the same spots as the screw holes from the crappy florescent fixture that was there beforehand. I only say that to point out that there is some standardization being considered when manufacturing the body of the fixture. In addition, it's a thin fixture and they have a knockout in the rear-center of the fixture that isn't the usual 3/8" size you normally see in things like electrical boxes. The problem is that some manufacturers don't include a smaller strain relief connector that fits the smaller knockout hole. This manufacturer includes one such connector. The alternative is that you have to use a step-up bit to expand the small hole to fit the 3/8" strain relief connector. I've done that before on other fixtures and if the knock-out isn't perfectly centered, the hole might be too close to the edge of the fixture and then you could have a mess on your hands. Not so with this fixture so that's all good.I'll definitely buy more of these when more the florescent bulbs fail (that are supposed to last X number of years) in my existing fixtures. I'll never buy florescent again. This LED is the way to go.
Recommended Products