Your cart is empty.
Your cart is empty.Product Description
No welding required
Use a flathead screwdriver to tighten the screws and easily complete the entire wiring process,
Wiring range: 30AWG-18AWG
0.1-1 square meter cable
Clear pin numbering
Both the front and back of the connector have corresponding pin numbers
PBT material
PBT material, insulation flame retardant, good material stability, not easy to burn in case of fire
Automatically extinguish when leaving the fire source
The wiring terminals are firm and reliable
The tension between the cable and the contact can withstand 12kg
The screw locking design is firm and not loose
The ABS shell adopts screw locking, which meets industrial standards and can be reused multiple times
Driver free compatible with multiple devices
Baud rate support: 300-115.2Kbps
Dmitriy V. Titov
Reviewed in the United States on February 6, 2025
Problem is that the terminal size says it can take 18 awg but it completely ignores the wiring jacket size. There is no way that your wires at 18 awg would fit if you used all or most pins. I need about 34 of 37.Otherwise the item is nice quality and I’d keep if I used 20 - 22 awg wire.
drums2metal
Reviewed in the United States on April 27, 2025
Came missing 2 set screws.. I looked all in the bag in case it was just too loose when shipped, but nothin (I have a ton of components that use the same size though, so I got that situated).. 3 of the terminals were jammed too far up to loosen (open), so I had to basically connect the wires by pinching fhem between the screw and plastic housing... 1 other CON is that I noticed the plastic housing of the terminals (not the whole outer shell that u put together urself) was easily able to be separated (with a slight wiggle) from the db37 connector.I bought a 2nd one and it was perfectly fine.. the 1st one must've been made on an early Monday or a late Friday.
Nick
Reviewed in the United States on December 14, 2024
I needed a pair of these to build a custom audio snake for my rack. (Or rather 're-head' one). This did work, and the connection feels reasonably solid. I would have liked slightly better construction for on stage work, however, which is why it's 4 instead of 5 stars.
jml
Reviewed in the United States on November 6, 2024
I used this without the shell to build some custom modem-crossover connectors via 25-pin ribbon cable. Neat and clean, and a screwdriver's included; what more could you ask for? Well-constructed and easy to use, belongs in any techie's kit if you use DB-25 cables at all.
Recommended Products