Your cart is empty.
Your cart is empty.3 Urethane tires specifically made for the 10" Craftsman Band Saws Models: 133.244510, 113.244512 & 113.244513
Will
Reviewed in the United States on August 15, 2024
works
Bmoremixoligist
Reviewed in the United States on March 7, 2024
I have a 3 wheel bandsaw, parts are harder to find. These tires seemed to be the best option for me. You will hear and see a lot of methods on how to get these on. (They are very tight fitting) I did not like the idea of heating them with a heat gun, because I was afraid the elasticity could be lost. So... I used my reversible ratchet clamp. I switched the clamp so that it would stretch the tires. I just gave it a few squeezes after it was tight. Immediately pulled the tire off and onto the wheel. Had stretched enough that it slid onto the wheel and then tightened back up and held nicely with no spinning on the wheel. Was a quick less than 5 minute process for all 3. Just be careful of the kick back when you release the clamp tension 😉
Hap K.
Reviewed in the United States on March 15, 2023
To short to be put on a 6 inch wheel with out a lot of proublems..Hot water-- heat gun-- Etc. Did not help..photo shows why....
John P. Krzyzanowski
Reviewed in the United States on March 3, 2022
Tough to get on. Could not get them on cold. Set them in hot water for a little and was able to get them on.
Bob Mccurry
Reviewed in the United States on October 4, 2021
It came with instructions that helped get them on was a great help
Recommended Products
$15.59
$ 6 .99 $6.99