Your cart is empty.
Your cart is empty.Product Description
Easy to Use:
1. The heating tube of the cutting pen can only be bent once, not repeatedly at one point. Bending repeatedly at one point may cause breakage.
2. Because of its special structure, the cutting pen can only cut medium and low density foam, and cannot cut materials other than foam. It is not suitable for high density or batch cutting.
3. Continuous cutting does not exceed half an hour, the power supply of the cutting pen has a switch, and the power supply can be prolonged after cutting off.
4. We will test the power again before shipment, so the pen will have slight foam marks, please rest assured to buy.
5. If you need to work for a long time, please choose a desktop cutting machine.
Product Usage Information:
1. Pen power supplies of different lengths cannot be mixed. Each heating pen has its own independent power. Mixed use is either not hot or will burn.
2. Do not touch any hot surfaces. The tips will become very hot during.
3. The continuous shall not exceed 0.5 hours, and the cumulative time shall not exceed 2 to 3 hours.
4. There are some errors in the length of the pen tip due to different factory batches. Please allow 1-3mm error due to manual measurement. Thanks for your understanding.
BLS
Reviewed in the United States on July 29, 2024
I may but have the best test case. All the pieces I needed to cut were 3 inches wide or less. Seems a bit flimsy but I'm hoping this will be functional for a few years.
jfm
Reviewed in the United States on December 8, 2023
Did not work as stated in ad. It does not work to cut out foam designs.
Chris
Reviewed in the United States on June 2, 2020
After the fail with the first hot foam cutter the vendor quickly sent a replacement however, it didn’t work either. It got warm to the touch only and didn’t get hot enough to cut a candle let alone foam.
David P Holmes
Reviewed in the United States on March 22, 2020
It didn't work when I got it not worth the hassle of returning it
GunnySGT1911
Reviewed in the United States on December 6, 2020
I was so excited to get this to use on a project. As soon as it arrived I opened it, checked the directions and plugged it in. I tried to cut a piece of foam and nothing. I tried letting it warm up for a minute and the wire was still cool to the touch. I should have paid more attention to the reviews.
James Griffin
Reviewed in the United States on July 31, 2019
Wire is loose in the collet. Can't be tightened because the collet is already as tight as it will go. So the wire just spins around in the holder if you bend it to do a form cut. Pwoer supply is worthless crap. Plugged it in used it for 30 seconds, managed to make one (1) cut and the supply fried out. This thing is a total POS.
ROBERTO GARCIA
Reviewed in Mexico on November 1, 2019
no muy facil de manejar pero sirve
Recommended Products