Your cart is empty.
Your cart is empty. Cermant 320 PCS 16 values 20 Each 1206 SMD Capacitor Assorted Kit 10P-22UF Chip Ceramic Capacitor Electronic Diy Kit
High quality and long life.
Nominal Capacitance :10P-22UF
Operating Temperature Range: -40deg/C ~105+deg/C
Temperature Coefficient: -55to+175deg C
This powerful and useful tool pack contains 16 most applied values with 20 Capacitor of each type , which can provide great convenience for your repair, research, DIY, etc. The assortments contain the following: SMD 1206 Resistor (each value is clearly marked)Resistor list:
10P 50v
22P 50v
33P 50v
47P 50v
220P 50v
470P 50v
102M 50v
222M 50v
103M 50v
104M 50v
474M 50v
105M 50v
225M 50v
475M 50v
106M 50v
226M 50v
Scott Baker
Reviewed in the United States on May 19, 2025
I bought these for the 4.7uF capacitors. I pretested before installing. 1 out of 20 was 4.6uF, the rest were 4.1 avg. I spot checked the 10uF it was 8.1uf. I checked a 5.6nF is was 4.8nF. Returned the whole lot.
Mac Fan
Reviewed in the United States on May 13, 2025
Nicely organized in order of value. The ones I have used tested within specs of the listed value. A good value.
Varistor
Reviewed in the United States on February 17, 2025
values for the as marked 22uF and the as marked10uf are not correct. The 22uF is really a 10uF and the 10uF is really a 4.7uF. the reason I bought them is for those higher values, Had to use something so I had to double up -- not hard to do with SMD caps. But I used a few so can not send back :(, lower values tested are correct.
Benoni
Reviewed in the United States on August 21, 2024
I use them to fine adjust the digital clock slowing it down if running too fast by soldering in parallel with the quartz.I use values from 1 to 10 pF to slow it down from running 5 seconds fast per month
Jim the Bookworm
Reviewed in the United States on August 23, 2023
The contacts are very inconsistent in terms of size and placement. Some barely have any metal on one end. One contact peeled off the cap when I soldered it to the board. Save yourself potential headaches due to failures and buy name brand capacitors.
T.S circuit repair
Reviewed in the United States on July 10, 2023
No problems with these caps
Algernon
Reviewed in the United States on May 19, 2023
I wanted cheap variety for a project that was going to involve trial and error, so I ordered two sets of these (40 each value) and tested every one of them.Labeled and Measured values (1kHz) with standard deviations were as follows:226 (22uF): 11.2 +/- 0.4 uF106 (10uF): 7.05 +/- 0.4 uF475 (4.7uF): 2.99 +/- 0.4 uF225 (2.2uF): 1.52 +/- 0.03 uF105 (1uF): 830 +/- 39 nF474 (470nF): 357 +/- 19 nF104 (100nF): 175 +/- 10 nF103 (10nF): 10.6 +/- 2.6 nF but these were distinctly bimodal with a group at 8nF and a group at 12nF 20 and 20 each222 (2.2nF): 1.36 +/- .01 nF these appear to be identical to the next group102 (1nF): 1.36 +/- .01 nF as above appear to be identical to the preceding group471 (470pF): 612 +/- 5 pF221 (220pF): 197 +/- 13pF470 (47pF): 44.9 +/- 4 pF also bimodal 20/20330 (33pF): 34.6 +/- 4 pF also bimodal 20/20220 (22pF): 27.6 +/- 0.2 pF100 (10pF): 10.3 +/- 0.5 pF also bimodal 20/20So I am going to split the four bimodal groups and lump the two clearly identical groups and end up with 19 groups instead of 16.The lower values are closer to spec than the higher ones, but there is clearly some sloppiness in how these packages are put together. As before without a way to measure capacitance you are going to be lost.
E. Motley III
Reviewed in the United States on May 9, 2022
The labeling is a little odd. No units, had to guess that "226" was 22×10^6 picofarads.Got me out of a jam, but I highly recommend one of the "Sample Book" assortments over a zippoc bag of cut tape.If you need the values listed, go for it, they were quality parts, just didn't fit my workflow as well as I'd like.
Recommended Products
