Your cart is empty.
Your cart is empty.Product Description
Customer ya zeen
Reviewed in the United States on May 9, 2025
Works great
Richard V Peck
Reviewed in the United States on May 24, 2025
Hot end fell apart in the middle of a print. There is a press fit between the heat break and the brass part. It isn't tight enough.
Dizzle
Reviewed in the United States on May 22, 2025
I needed a hardened steel nozzle and this was a drop in replacement. No issues (so far), just needed to change the type from Brass to Hardened Steel and watched it re calibrate. Also printing 5-10degrees higher since its hardened steel.One thing to note that the heater block is significantly smaller than the original but no issues here.
EF
Reviewed in the United States on April 26, 2025
Bambu style hotend for your Kobra S1/S1C printer. Works out of the box. No issues with thermistor reporting the wrong value or plastic leaking from the threads. Same nozzles as other aftermarket Bambu parts; 7mm long m6 threads.Compared to the original this definitely an upgrade. The heatbreak is all metal. No PTFE insert. The block is significantly smaller so it heats up and cools down faster. Other than loosing support for Volcano nozzles, no downsides so far.Only tested with ASA so far but no issues printing a benchy with stock hotend settings.Bed leveling will be required before printing. Also temperature stability is way off due to differences in heater and block. So a PID calibration should be performed. Vibration calibration isn’t necessary; I tried it without performing this step. VFAs are minimal but should probably be completed to achieve maximal print quality.
Alastorr
Reviewed in the United States on June 3, 2024
Killed the ceramic on my stock k1 max and this was my replacement, it works perfect, apply a bit of thermal compound on the heatbreak if you use the included one, I installed a ceramic tube heatbreak in mine so I got a small upgrade as well as a new hotend I also replaced the nozzle with a micro swiss it prints great better than when I pulled it out of the box
DylanB
Reviewed in the United States on May 13, 2024
The hotend works great. I will start off by saying that. My issue is that it did not come with replacement hotend screws (i had to drill one out to pull the old hotend off.) And the thermistor cable is long enough to plug in but it would be nice to see it be about 10mm longer.
Coach Braczy
Reviewed in the United States on March 29, 2024
works great as intended. using anycubic kobra 2 max
John Henson
Reviewed in the United States on March 13, 2024
No issues at all, It's a good replacement in my Kobra 2 Pro.
Recommended Products