Your cart is empty.
Your cart is empty.Product Description
A jam nut is a low profile nut, half as tall as a standard nut. Used as a type of locknut where it is jammed up against a standard lock nut to lock the two in place. Also used where a standard nut would not fit.
From the Manufacturer
A jam nut is a low profile nut, half as tall as a standard nut. Used as a type of locknut where it is jammed up against a standard lock nut to lock the two in place. Also used where a standard nut would not fit.
King Canute
Reviewed in the United States on March 30, 2025
Worked perfect. I could not get it at ACE Hardware or Fastenal. Thanks
btapp
Reviewed in the United States on September 19, 2024
Perfect fit and high quality!
MALINDA JANE
Reviewed in the United States on April 4, 2023
This fits a 1995 Polaris 300 2stroke 2x4 crank shaft and maybe other 300 2strokes
michael a ortega
Reviewed in the United States on September 22, 2022
They were not the description size. A little too big!
joe mahalo
Reviewed in the United States on June 12, 2022
Its a nut, it works
averigoodman
Reviewed in the United States on July 22, 2021
This hex nut worked perfectly on my axle as a spacer. It threaded on smooth and was the perfect size
Customer
Reviewed in the United States on March 7, 2021
Ordered this for my Dewalt planer. Perfect fit!
Tim Stafford
Reviewed in the United States on October 4, 2021
Quicker and cheaper than ordering the Dewalt part # for the DW733 planer cutterhead. Not sure if mine was shipped without the nut or it worked loose, but my drive pulley broke off and no nut to be found. Use some red loctite on this replacement nut if you don't plan on removing it again. I replaced the bearing (NACHI 6204NSE) while I had the cutterhead out, and don't plan on removing it again for maintenance. Loctite, then torque it down and you'll avoid my situation.
Recommended Products
