Your cart is empty.
Your cart is empty.Product Description
John Y.
Reviewed in the United States on May 8, 2025
These fit as expected. Quality is good.These are what you're usually going to want to use on cylinders.Most have orb holes, and you're usually going to want the elbow so the hose can run parallel to the cylinder.These are perfect for many applications.Great item!
TonyTheToolGuy
Reviewed in the United States on May 29, 2025
What can I say, these look just like other JIC/ORB fittings I've used. They appear well-made, fit and finish are nice. Corrosion will raise its head in years, so I can't say much, but they appear well crafted.
Joe Blount
Reviewed in the United States on April 26, 2025
They seem to fit well. The machining is smooth, no abnormally sharp edges.I used them for the hydraulic cylinder i added for side tilt on the 3 point hitch of my tractor. I had started with straight fittings comming off the cylinder and didn't like the way the hoses laid after I adding a pilot check valve to prevent the settling. These let me set the angle of the hoses much better.When rigging osmething hydraulic I prefer these oring SAE elbos over the NPT elbos because you can spin it to exactly the angle you want, then tighten the nut with the oring. With NPT fittings, I'd be tightening and loosening trying to find the best angle, then it would leak.BTW, if you have trouble with NPT hydraulic fittings leaking, clean the threads and put a heavy dose of medium strength (blue) thread locker on them. That stuff does not dry, it cures. Its a chemical reaction triggered by the ions in the steel. So it will set up and seal the threads. When I have to use NPT on hydraulics, that's how I make it not leak.
Recommended Products