Your cart is empty.
Your cart is empty. The iCreatin PoE Injector can save you money by using an existing Ethernet line to deliver data and power.
The iCreatin PoE Injector can easily connect IEEE 802.3af/at/bt Compliant device to a non-PoE LAN switch port.
This PoE Injector can be used to connect a wireless access point, IP phone, network camera, or any IEEE 802.3af/at powered device to a LAN switch.
Reduce Wiring Costs With the iCreatin PoE Injector you can dramatically reduce wiring costs by powering devices through your existing Ethernet line rather than running new AC power lines.
To use this PoE injector, all you need to do is connect the iCreatin PoE Injector to the LAN switch port, and then use your existing Ethernet Cable to deliver DC power and data to your device.
Protect Your Equipment Now that you are running DC power to your networked equipment through the Cat5 cabling, you need to be sure that your devices are protected from power problems.
The iCreatin PoE Injector is designed with short circuit protection Over Current and Over Voltage Protection, keeping your devices safe. It is also protect your products from overloads and high voltages
Specifications
2 Gigabit Ethernet ports
Input 100-240V voltage
Output 48-56V, Max 65W High Power ,
Data rate: 10\100\1000Mbps,
Power feed: Supports both Mode A and Mode B
Deliver power up to about 328 feet(100 meters)
What in Box?
1x 60 watt Gigabit PoE injector
1 x US power cord,
1x user guider
Wally
Reviewed in the United States on September 9, 2024
Does not work, no power cord included.
chris
Reviewed in the United States on December 12, 2023
Good poe
J
Reviewed in the United States on June 25, 2021
Used to power Ruckus R710 AP
Camco
Reviewed in the United States on May 17, 2021
This device caused me MANY hours of wasted time.The damned thing worked INTERMITTENTLY, shutting down randomly. It had me checking over 100 feet of wiring over and over, and nearly convinced me that my perfectly functional $400 camera was the problem.Intermittent failures are THE WORST. It's very difficult to diagnose when the failure disappears when you're looking for it.After failing unpredictably many times, the device finally began shutting off every time a small load appeared on its output. No load or low load, works fine, everything nominal. A load of perhaps 100 milliamps and it shuts OFF. JUNK.
Anthony
Reviewed in the United States on October 26, 2019
This works well
Brad I
Reviewed in the United States on September 29, 2017
Works great for my ptz camera and alot cheaper than what the camera company wanted, perfect!
Reviews, Teardowns, and More
Reviewed in the United States on February 3, 2017
It works but if you shake it something rattles inside
Joanne M.
Reviewed in the United States on October 9, 2015
Cheap Product but works well. Currently powering a Meraki MR12 over PoE. Worth the extra few dollars to get the 60W version.
Recommended Products
