Your cart is empty.
Your cart is empty.Part number: 65345.
Dr2
Reviewed in the United States on August 12, 2024
The belt worked for my mini lathe it seems to be constructed fairly well but it did shred a little when running. I will buy another one as a back up
Chris Humphries
Reviewed in the United States on July 27, 2024
Works, but it is a bit smaller than the original belt. Needs to be a centimeter or two larger in diameter for a better fit.
BRITTFREE
Reviewed in the United States on February 19, 2024
Husband said it did its job and worked well
John B. Stark
Reviewed in the United States on October 22, 2024
figuring out the left-hand threads and getting everything aligned was challenging but it was worth getting done. Done for a couple of years anyway
Michael K.
Reviewed in the United States on April 18, 2024
It fit & it works nice replacement belt for my lathe
Bob M
Reviewed in the United States on March 20, 2023
Hardest part of the belt change was knocking the shaft out of the headstock. After that was accomplished, re-assembled with new belt and put lathe back in service.
777
Reviewed in the United States on May 23, 2019
Better quality belt than original. Does seem a little tight though.
gnef
Reviewed in the United States on July 20, 2017
I just installed this in my harbor freight lathe. The original belt lasted for many years, and this one definitely seems better. It was a great fit, it is just a bit of a pain to press out the bearing in the headstock to replace the belt, but it wasn't too bad. I checked the tension and speed settings with the belt, and everything is as smooth as expected.
Recommended Products
$49.90
$ 24 .99 $24.99