Shopping Cart

Your cart is empty.

Your cart is empty.

80A Motor ESC Speed Controllers, Dual Brushed 80A Brushless ESC (Electric Speed Controller) Splashproof for 1/8 1/10 RC Car Truck(80A ESC) Electric Speed Controllers

Free shipping on orders over $29.99

$36.08

$ 18 .99 $18.99

In Stock

1.Color:80a Esc


About this item

  • 4 Modes---Four operating modes to adapt to various vehicle front/rear/rear forward/backward forward/reverse (also known as "grab mode") ship (note: Fwd=forward, Br=braking, Rev=reverse)
  • Built in BEC---The built in BEC switch mode has powerful output. Easy to use dip switch to set ESC parameters.
  • Automatic Throttle Range Calibration --- Automatic throttle range calibration, easy to use. Easy to set ESC parameters with dialing switch, wonderful replacement.
  • Multiple Protection---Low voltage cut-off of the battery/thermal (overheating) protection/throttle signal loss
  • Dustproof---Small size, built-in capacitor module. Strong current carrying capacity. and dustproof, suitable for all-weather competitions.



Product Description

80A Motor ESC Speed Controllers
80A Motor ESC Speed Controllers
80A Motor ESC Speed Controllers

Jody marshall
Reviewed in the United States on May 28, 2025
Plugged it in and turned it on immediately made a pop and sent full power to the motors
Joshua
Reviewed in the United States on May 28, 2025
The media could not be loaded.
Ron inman
Reviewed in the United States on September 30, 2024
Wasn't aware it came with A programing card very tunable just installed and a quick test on a two s super clod buster running stock motors and it stated pretty cool and seam very smooth if your setting up a clod to crawler or sport around a track works good as cheap energy level esc would def buy again
Beaumont
Reviewed in the United States on January 16, 2024
Pros:- 80A and did handle 4S lipo fairly well (at least it didn't go to smoke when I used one)- Programmable, so there's flexibility in settings (important to me is modulation and drag brake)- Ability to run 2 brushed motors (not that I'm planning to, but this allows 4S to be ran)Cons:- Some of the program modes (double-digit numbers) were confusing to figure out, like mode 12 on the chart is represented as "11" (based on what is lit up) on the programming card. So anything that that is written on the programming chart, just deduct 1 as represented on the card. You'll get it- Somewhere I think this was rated as water-resistant, but the physical feel of it isn't--but I could be wrong and will more likely test this out. I may just end up with a fried ESC, we'll see- Drag brake's a bit on the lacking side but better than the stock TRX4 ESC- Best suited for 2 motors, if only using 1, there will be excess wiring that needs managingWill I recommend? It's a 50/50. Really depends on what you're looking for. Again, it's more usable for 2-motor application, otherwise there are other options
heath brockway
Reviewed in the United States on August 25, 2023
This esc is made for a dual motor setup although I only uses on a single brushed 540 sized motor it still worked well. Listed output is 80amps which I'd consider suitable for 1/10th size. Comes with a deans style connector installed and is ready to go. Response is as expected and depending on the transmitter used greatly effects (at least what I found) response and throttle control. This would be perfect for a tracked setup where two motors are used to get the full potential out of this. It being described as splashproof is a maybe as it isn't sealed but it does have a case...so use caution If you're using this in wet conditions.
LonnyW
Reviewed in Canada on June 6, 2023
Was quite surprised with this ESC. Using with single 540 45T motor on 3s. Programmable parameters are adequate for crawling.
Charlie
Reviewed in the United States on May 4, 2023
12t motors make this thing blazing hot and tgeres no where to mount cooling fans on the esc. Really good connectors, gets very hot but hasnt stopped yet!
Nelson
Reviewed in Canada on May 13, 2023
Dose not work with burshless motors temped to hook up the my burshless system and started to overheat and smelled like something was burning I unplugged my 2s Lilos and to prevent any damage to my car. the ESC Is not made for burshless systems as the description stats!
Recommended Products