Shopping Cart

Your cart is empty.

Your cart is empty.

ADnet 10G Fiber to 10G Copper Ethernet Converter – Open SFP+ Slot – 10GBase-T to Base-R – Includes Cat7 UTP Cable – 10Gbps Optical Media Adapter

Free shipping on orders over $29.99

$169.00

$ 80 .99 $80.99

In Stock

About this item

  • 10G Base-R (Open SFP+ 10G slot) to 10G Base-T UTP Copper RJ-45 port Fiber Media Converter;
  • Convert & Extend Copper Distance of Your High Speed 10gbps network connect far beyond – your SFP+ fiber transceiver distance is the only limit now;
  • Supports any SFP+ 10G transceiver of your choice, be it Single or Multimode, or even WDM single optical fiber type – it’s pure Open SFP+ slot;
  • Important!: 10G base-T RJ-45 UTP port will autoadapt (autosense) to 1000Base-T, 2.5G Base-T, 5G Base-T and 10G Base-T connection at user side, but fiber port – slot accepts only 10G SFP+ (10 Gigabit) SFP+ transceivers only.
  • You Get Free 1m (3.28 ft.) UTP Cat7 (10G Network Ready) UTP RJ-45 patchcord in set with every 10G Media Converter!



Product Description

10G SFP+ to SFP+ fiber to fiber converter is a fiber-to-fiber type 10Gbps device that acts not only as fiber optic media converter or as a fiber optic repeater for long-haul transmission, but is an all in one solution to get 10GE fiber network to be Re-Amplificated, Re-Shaped and Re-Timed.

3R Repeater / Extender / Media converter for all your 10G fiber network mode & wavelength conversion needs.

Unit supports only 10G SFP+ type modules standard MSA compliant SFP transceivers!

It is commonly used in network backbones (SAN, LAN, MAN, WAN). Supports various protocols such as SDH / SONET STM-64 / OC-192, 10G Fiber Channel, 10G Ethernet, etc. can be used in a telecommunications room, R&D lab, data center, etc. Supports any standard SFP+ 10G with 850nm, 1310nm / 1550nm / CWDM / DWDM optical wavelength conversion, 10GBase T copper modules also supported.

Product features

  • Jumbo frames support
  • Transparent signal transmission and low latency
  • The rate supports 8.5Gbps~11.7Gbps
  • Supports OEO 3R functions: signal amplification and regeneration, waveform shaping, clock retiming
  • Easy installation - Plug & Play

Wide Range Protocol Support

8.5G Fiber Channel SONET OC-192, SDH STM-64 (9.95Gbps) 10G WAN (10Gbps) 10G LAN (10.31Gbps) OTN OTU-2 (G.709) (10.70Gbps) 10G LAN with 255/237 FEC coding (11.09Gbps) 10G Fiber Channel (11.32Gbps) 10G POS

Technical Parameters

  • Transmission rate:8.5Gb/s-11.7Gb/s
  • Interface Type: SFP+ standard slot
  • Power supply input voltage:DC 12V (AC adapter comes in set)
  • Power consumption:≤4W
  • Operating temperature:0-℃~60℃
  • Size (L*W*H):110mm(L)*100mm(W)*30mm

モノスキ
Reviewed in Japan on June 22, 2024
最終更新日:2024/06/221.検品パッケージ開封後の内容物は以下の通りでした。〇内容物①(メディアコンバーター)本体②ACアダプター③本体固定具等④LANケーブル⑤クリーナー等⑥説明書以下、特記事項のある項目について記載します。①(メディアコンバーター)本体本体は金属製でSFP+x1、LANx1です。但し、端子部のカバーはありませんでした。②ACアダプター入力は100~240Vで出力は5V/2A、PSEマークも菱形がありました。③本体固定具等ゴム足(x4)とL字金具(x2)、面テープ(x1)がありました。但し、L字金具用のネジは本体両側面にあるカバー止めを兼ねたネジを使用する模様です。④LANケーブルCat7(STP)ケーブルが1本同梱されており、長さ1m、太さ約6㎜でケーブルは固めでした。⑤クリーナー等クリーナーと何故か鉛筆がありました。⑥説明書説明書は日本語で作成されていました。2.感想等2-1)使用について自宅環境で試してみましたが、現状では特に問題なく使用出来ました。(当方の環境の制限でファイバー10G~STP2.5Gですが・・)又、LAN側のみですが、オートセンスで10G以下の環境でも接続できるのは良いと思いました。(当方の場合、検証環境に応じて1G等も使う事もあるので)2-2)その他感想等(不満点)不満点は1点で、端子用カバーが無かった点。説明書にも"使用しない時はカバーをして下さい"とあるのですが、そのカバーが無いのが残念でした。(当方の場合、検証環境で使用しており、良く環境変更をするので外す場合もある為)3.評価10Gファイバーを有線LANへの変換を手軽に出来るのは便利と思いました。しかしながら、不満点(先のキャップが無い点)から☆4としています。後はこのまま使用しての耐久度や、現状ではLAN側が2.5G環境での使用なので、LAN側も10G環境で使用できた際には追記出来ればと思います。(但し、時期は未定です)以上〇更新履歴2024/06/22 初版
Destroyer2433
Reviewed in the United States on May 12, 2024
A+
Sean-Ryan S.
Reviewed in the United States on April 20, 2023
This unit is fairly inexpensive for a 10Gb Media converter. It works perfectly out of the box. My only complain is that it runs extremely hot since it has no active cooling. If I were to leave my finger on the SFP module it would have left a minor burn. I had to setup a small desk fan to blow air across/through it's ventilation holes. Once it has some active cooling it runs very cool.
Cricket Man
Reviewed in the United States on April 27, 2022
Amazing customer support! I had an atypical use case which led some issues but customer support responded super fast and made it right. the interaction was genuine.My use case was a link speed conversion rather than the fiber/copper conversion. I had a multi-gig (5G-Base-T on UTP side and 10G-Base-T OPNSense on the other side) Even tho the connection was established, it was still 10G-Base-T on both sides which led to collision errors for the upload (TX) packets. Download (RX) was fine.I highly recommend their business based on my experience with the customer support.
letmepicyou
Reviewed in the United States on April 20, 2021
If you want to run Fiber To The Desktop, this is a key part of that equation. You'll need an SFP module for your provider / setup, of course. But if you want super speed to the desktop, this is where you want to be. Good for servers, too, of course. But bah. FTTD is the WTG. Your PC be smokin on this.
Dipped in Ink
Reviewed in the United States on April 10, 2021
Ever need to run, say, 10G ethernet over a kilometer of cable and then convert it back into copper again? Believe it or not, if you have a server room, this is an occurrence! Slow coax cables are a thing of the 80’s, and this little tiny box pushes media in a massive way, with quick light.On a more personal note, like for my house or a small office, I have found enjoyment playing with fiber optics in my home. Do I need that kind of power? Maybe not. Or maybe it is the future to make my home as fast as possible! It is, however, fun to move data that fast. This is not for home use really. It’s set up for pro. What I do know is that this converter is smart, fast and worthy.
Customer
Reviewed in the United States on November 19, 2019
I needed something that is extremely easy to install, and this one was as easy as it gets. It also came with a 10G Cat7 UTP patchcord which are quite pricey if bought separately. This is an inexpensive alternative to 10G switch which works like a clock. Was able to get 10G speeds over the copper to my workstation, without any additional settings adjustments. I installed this switch in the server room with OM3 cable running to it, just FIY. Anyways, good purchase, recommended.
4K Fan
Reviewed in the United States on April 23, 2019
This is get our 10 gigabit network going at work , and it works as advertised.
Recommended Products

$7.87

$ 3 .99 $3.99

4.4
Select Option

$21.55

$ 10 .99 $10.99

4.3
Select Option