Your cart is empty.
Your cart is empty.Product Description
Includes a 9-Switch Controller with weather-proof plug-n-play harness that not only controls 8 valves individually, but also improves the appearance and proper operation on every set-up.
Fully Sealed Enclosure
Mounting Hardware
Screws and nuts are included with the manifold.
This manifold will inflate and deflate the air springs using two 1/4" NPT Intake and two 1/4" NPT Exhaust ports.
The ports connecting the air line to the air spring are 1/4" NPT while the ports connecting the air lines to the air gauges are 1/8" NPT.
raul rubalcava
Reviewed in the United States on April 28, 2025
I bought this over a month ago, I just got around to installing it. One of the switches on the controller doesn’t work. I can’t return it and there is way to get a hold of the seller. Beware, you’ll never get your money back since I waited to long to install and I can’t return it now. I lost money and this valve doesn’t work now.
Paul F.
Reviewed in the United States on April 12, 2025
The controllers are junk I've bought three of these and everyone would have issues they would randomly not go up or down. One solenoid stuck open while driving. My right front dumped on me at 40 mph shredded my tire bent my fender and other damage. That valve block wasn't even a year old. This last one I have I was having issues again in the first week. I swapped the controller for another brand, better quality and I have had no issues with the valve block since then.
Customer
Reviewed in the United States on September 24, 2024
Hooking it up is easy no problems the problem is it don't work right one of the functions don't work at all and some of the others just work when they want to
jeff scott
Reviewed in the United States on August 4, 2024
Not all the buttons works as they should. I suspect maybe a diode inside is wired wrong or bad. Center all up for instance doesn’t put all 4 up. Price is fair but beware.
J. Kelley
Reviewed in the United States on August 23, 2024
I've been using this type of manifold and valve body for a while and they work pretty good for the airbag set up on my truck. This one is a particularly good deal because it includes the switches and harness. Not all of them do!Pros* Super easy set up because all the connections are direct to the manifold, you'll save a mint on fittings and tape as compared to separate valves.* These valves flow a reasonable amount of air for a passenger vehicle. If you have huge airbags, you may want to do valves with a larger orifice. This setup flows a reasonable amount of air so you can control how much air goes in the bags.* All holes are drilled and tapped NPT so they work fine with standard air fittings.Con:* The seals on these dont last forever in harsh environments, but the solenoid body comes apart so technically you could replace them. It's probably more cost effective to replace the whole unit.* No instructions or labels on the switches.Things to note:The Switch body is wired roughly as follows:Top row - Left Front - Both - Right FrontMiddle row - Left F/R - ALL - Right F/RBottom row - Left Rear - Both - Right RearAgain there are no labels on the switches so you'll just have to remember or make your own.This body is drilled to have individual 1/8" NPT pressure sensors to monitor the pressure in each airbag individually. If you're not using gauges, you'll need to plug these holes. The input and exhaust is drilled straight through so you could input or exhaust air from both sides. Again a plug will be needed if not using all of these.
chris freidhoff
Reviewed in the United States on July 7, 2024
I purchased this taking a chance that it could be low quality and it sure is. Of course I purchased it over a month ago and never installed it until today. One of the valves just leaks on the left rear. Constantly filling that corner. I tried to cyle the valve and see if it would seal up. No good and too late to return it. Do Not buy this junk
race
Reviewed in the United States on July 11, 2024
Every one of them work okay but the one front right does not work it goes up but it doesn't come down, not even a click when I press down. I have to disconnect the air hose to release the air so I'm thinking it's something wrong with the wiring inside the remote or something else.
Zach B.
Reviewed in the United States on April 25, 2024
The top switch doesn't function so you can not raise the two air bags at the same time. Just installed and doesn't work out of the box of course I waited til after the return window to install.
Recommended Products