Your cart is empty.
Your cart is empty.Center Height is 52 - 52.5 mm which is pre-designed and prefixed for Myford Lathe Machines. Can fit to Larger Machines by using Packing to Adjust Center Height * Can turn up-to a 50 mm diameter Metal or Wood Ball. Can be Adjusted for Various Sizes of Balls.* 2 Pcs x 3 Sided Indexable TNMG16 Tips Design For Internal & External Turning *Free Shipping All Over the World. Delivery within 1 Week Maximum.
Kris M.
Reviewed in the United States on March 11, 2025
Works great for aluminum! Haven't tried stainless yet? That will be the real test!
dragoncutlery
Reviewed in the United States on August 21, 2023
shipped without handle and there's a gap on the bearing assembly that will lock up the rotating mechanism if you try and tighten the screw all the way i had to make a bushing to keep the screw from locking it up and be able to be tight enough to not loosen on its own
Brian Erxleben
Reviewed in the United States on January 4, 2022
This is a joke, there is no fine adjustment on the tool block and it rides in a square groove not a dovetail.
Tim
Reviewed in the United States on January 22, 2022
Awesome tool for my custom titanium driveshafts for RC race cars… just pull the compound off and it bolts directly onto the cross slide… the tool itself needed to have .020” shims under it to center it but it’s very perfect
Customer
Reviewed in the United States on March 14, 2021
Was not able to use it on my lathe,but it's a well designed tool,
Cliente
Reviewed in Spain on November 17, 2020
que se puede usar para hacer trabajos en esfera y cóncavos.
jephi
Reviewed in France on July 8, 2019
j'en rêvais faire des boules avec mon touret bien mon rêve est réalitéquelques modifs d'adaptation et c'est joué
Cliente
Reviewed in Spain on July 29, 2019
Buena herramienta a falta de adaptar al torno
segard jonathan
Reviewed in France on February 26, 2019
reception tres rapide et produit conforme au descriptif
Rich
Reviewed in the United States on December 14, 2019
5stars from a non machinist. I adapted this to use on a 9 in. South Bend lathe. Worked perfectly. Got an acceptable finish on my piece. No sanding or filing only wire wheel to shine it up.
UNT ETEC
Reviewed in the United States on July 13, 2018
Haven't used it yet as I need to make a raiser for it to fit my lathe ( Emco V10P) BUT initial impression is as expected, cheaply made, needs finishing ( deburring, loctiting screws etc) as another reviewer stated it should have a bearing on the pivot as I can see it will be a high wear point if used anything more than rarely but it should do the minimal work I'm planning on. Needs a scale on side for referencing radius it is cutting to at least get you in the ball park of what your trying for
Tryon
Reviewed in the United States on February 23, 2018
Works ok,, but bearing could be improved to make it have less play... Still just a little loose, which doesn't give a great finish. A little tricky to set the diameter of the cut (manual measure).I had to make a custom fixture for my lathe, but it worked out ok..
Recommended Products
$99.99
$ 48 .99 $48.99
$60.00
$ 29 .99 $29.99