Your cart is empty.
Your cart is empty.
Specifications:
Material: Rubber
Color: Black
Length: 4 m/13 Ft
Width: 14 mm/0.55 inches, 19 mm/0.75 inches
Package Include: 1 x 14mm Weather Stripping + 1 x 19mm Weather Stripping
Installation:
1. Clean the location to be taped.
2. Wipe on the adhesive aid.
3. Peel off the adhesive backing and start sticking.
4. Apply proper pressure to ensure tightness.
5. Cut the tape and the installation is completed.
Attention:
If the surface is not smooth enough, it is recommended to use tackifier to increase the viscosity.
Do not wash the car within 3 days after taping.
When the temperature is low, you can use a hair dryer to heat the backing adhesive to fix it more firmly.
Sergii Buth
Reviewed in the United States on January 4, 2025
I have a leaking windshield due to the installation flaw. Sealed the gap between the windshield and the roof - worked like a charm. Holding well 3 month so far. Survived a few car washes (no high pressure close washing).
brian
Reviewed in the United States on April 5, 2025
Ok product did not last very long
Danny Stampley
Reviewed in the United States on April 23, 2025
It looks quality but I still haven’t used it yet.
Chicanamami79
Reviewed in the United States on April 15, 2025
Outstanding product with versatile uses. Just take your time installing it and massage it out ever so smoothly. Reasonably fair product and purchase.
Regular.
Reviewed in the United States on September 23, 2024
Doesn’t fit correctly and adhesion is a bit week
D Farr
Reviewed in the United States on November 6, 2024
Worked just fine. Came with 2 sizes, the larger one worked well for me. Stuck well after I cleaned the surfaces and looks great. Highly recommended.
DJ
Reviewed in the United States on November 13, 2024
This trim molding is great and worked thus far as desired. This is what I did and what I could have done better. 1. Laid out the desired length oitside to bake in the sun and lay flat. 2. Clean the area with adhesive remover followed by 70% alcohol to wipe the oil away. 3.Repeat step two until it's perfect. 4. Lay out the strip along the area and stand back to what it looks like especially around curved glass. 5.Get a helper or painters tape and lay out a strip directly above your desired place as a guide. This is the step I wish I did better... 6. Set the first edge down and press firmly. Hopefully it's warm out as it helps to manipulate the seal. A hair blower or heat gun helps but not a must. Continue removing the backing tape and pressing along. 8. TAKE YOUR TIME. 9. Trim the edge and take picture for the Gram. So I wish I had used the painters tape to create an edge so I wouldn't have a slight dip in the line but unless your looking for it you won't see it. Also keep in mind that the gaps my not be all the same depth and that can cause shifting so check that and note where it is to adjust. Adhesion is great and I've been through 10 carwashes after letting it sit for 4 days without being wet or disturbed outside of normal driving. It's really easy and the results are great and fit great. Thanks for hanging in and residing my ideas.
Disco Queen
Reviewed in the United States on October 27, 2024
Used this in my sons car where water was getting inside when it rained, tight seal
Recommended Products
