Your cart is empty.
Your cart is empty.Our Pac-Lite Picatinny Scope Bases easily mount on the Pac-Lite Barrels.
Gunman
Reviewed in the United States on July 12, 2024
Bought this base for a browning buckmark it looks good fit perfect came with mounting screws and does the job
Charles in Richmond
Reviewed in the United States on February 1, 2024
Excellent rail to mount an optic, holes lined up perfect to factory tapped holes in my 2009 Browning BuckMark URX. I would purchase the same rail with the built in rear adjustable sight if I had to do it over but money was tight.
Zenomorf
Reviewed in the United States on January 31, 2024
Wasn't sure if this would fit a Browning Challenger III. The Challenger looks like it was the precursor to the new Buckmarks. Took a chance - it fit's perfectly!
Sol W Garcia
Reviewed in the United States on October 20, 2022
The rail is well made and it fits my Buck Mark Camper with UFX grip perfectly. I also like that it came with its own pair of screws and they don’t need the star washers that are required for the original Buck Mark sight base. After half a drop of blue Loctite, the screws stay put even after a few hundreds rounds during range visit. It is expensive and it doesn’t even come with an iron sight, but my scope fits on this base nicely and it is very accurate to shoot with a scope. It greatly improve my groupings at 15-yard distance. Buck Mark is fun without the scope, but it is super fun with it. If you are on the fence, hope it is helpful for your decision making.
BearCub
Reviewed in the United States on April 29, 2021
I had the same rail for the buckmark but with the built in rear sight. Unfortunately that one did not accommodate the full length of the C-More Railway red dot sight. So I had to swap it out. Drop in fit, no fuss, well machined, good hard finish, and no interference to slide function whatsoever. AND it fit the C-More Railway perfectly... mission accomplished.
Dallas M
Reviewed in the United States on August 13, 2020
Works as described and was very easy to install. I'm an experienced gun owner, having many different rifles, pistols, and scatter guns over the last 50+ years. If you can turn a screw driver you can install this on the Browning Buckmark, you don't even need instructions it's pretty self evident, just be sure to keep the screw orientations correct and buy a small tube of thread locker. Would (and have) recommend to my friends.
Richard Carter
Reviewed in the United States on December 21, 2020
Easy to install and a perfect fit. I read elsewhere that folks had to drag the mounting holes with a drill. This was not needed and may be the result of an incorrect mounting procedure. The barrel is held in place by two screws, one on the front of the frame and the other on the top of the barrel. The first screw must be loosened to allow the barrel screw hole to align with the rail. Before doing any drilling, examine the original sight rail and compare it with this accessory rail. The holes should be the same distance apart. If they are, don't be drilling anything. You'll degrade accuracy.
Bruce E. Layne
Reviewed in the United States on October 31, 2017
A bit pricey for what it is, but the Picatinny rail for the Buck Mark pistol is well made and works perfectly. Installation was simple and intuitively obvious. I bought a similar rail for a Mossberg 590 recently for a little over a quarter the price and it was almost as nice, so I started to deduct a star for value but I didn't because the high quality justified the high price in my opinion, and it was worth the price to mount optics on my Buck Mark pistol. I have a tiny Vortex Venom red dot to mount, bit so far I've been playing with a little green Crimson Trace laser and that's a lot of fun too.
Recommended Products
$36.00
$ 18 .99 $18.99