Your cart is empty.
Your cart is empty.David kinder
Reviewed in the United States on April 4, 2025
It fell off, so I reordered and used superglue to get it to stick.
Heather Mencer
Reviewed in the United States on December 17, 2024
We have a few cameras that our staff uses and one of them was missing a dial. This was a quick, cheap, easy fix. You would never know it was a replacement.
Fredy Usuga Pelaez
Reviewed in the United States on September 9, 2023
si se te daña el de la 5dm4 apenas es
henrilucwolf
Reviewed in the United States on April 30, 2023
It fit perfectly on the dial.I was worried that other reviews had mentioned single sided adhesive and it not fitting into the correct position re: the alignment nub, but neither were my experience.
Rome24
Reviewed in the United States on September 30, 2022
The dial is fine, but the 3M tape included is completely useless! The tape only has adhesive on one side so there's no way you can attach the dial using it. Just use superglue.
Cynthia A.
Reviewed in the United States on October 20, 2022
The camera top mode dial cover lid cap was perfect. I used crazy glue to secure it in place vs. the adhesive strip that came with it. Very happy that the mode dial was available on Amazon.
John J. Watkins
Reviewed in the United States on June 9, 2020
Not much to say about a Mode Dial cap. It fits. That’s about it. Now, the envelope it came in was a bit of overkill and could have been a LOT smaller, perhaps the size of a letter envelope?
Jim
Reviewed in the United States on December 28, 2019
I read the reviews and didn't bother with trying the enclosed tape to mount it. I used Loctite super glue and it was installed in seconds. I put some clue on a piece of paper and used a toothpick to apply a small amount on the 3 raised areas on the dial. I then placed the cap on the dial being sure to align the cap with the slot on the dial. I held it in place with finger pressure for 20 seconds and it was done.
Recommended Products
