Your cart is empty.
Your cart is empty.**Verify the part fits before purchasing** Specifications: Description: Stabilizer Assembly Length: 17" - 23 1/2" Inside Diameter: 3/4" Notes: W/pin, shackle, and coupling. W/o brackets and U bolts. Adjust from 17" to 23 1/2". Compatible with/Replacement for Ford/New Holland: D9NNB856BB, X-A-D9NNB856BB, X-HFD9NNB856BB Replacement for: Ford/New Holland: 230A; 2310; 250C; 260C; 2610; 2810; 2910; 3230; 3330; 334; 335; 3430; 3910; 3930; 4110; 4130 3 Cyl 90-99; 4610; 4630; 4830; 5030; 530A
Harry B.
Reviewed in the United States on December 18, 2023
This stabilizer bar made it a lot easier to adjust compared to the original turn buckle type. This was not a direct replacement item for a New Holland 1720. I had to modify the connection at the tractor with bushings and a different bolt.
Deloris G.
Reviewed in the United States on November 1, 2023
Good value & quality material.
Joe OBrien
Reviewed in the United States on October 29, 2023
Fit my 1987 Ford 2110 perfectly. Easy install!
Ryan McKibben
Reviewed in the United States on June 20, 2021
This is a great quality addition to my tractor. The steel used is hard and the holes are clean and don’t have burrs from drilling that can make it hard to get the pins in and out. The only thing I noticed was that the paint chipped almost immediately while tightening the bolts that hold it onto the lift arms. Not a big deal but annoying.
dpc
Reviewed in the United States on January 18, 2020
They keep the implement more stable. They are easier/quicker to adjust. The only thing I don't like is that sometimes the inner bar twists a little. This makes it hard to drop the pin through. Because the hole does not align properly. I think I can remedy this by loosening the bolts, a little, where it connects to the axle.
William R Brown III
Reviewed in the United States on January 10, 2020
They work. The brackets that fit to tractor under the axle were not made the best. One of the 2 I bought were slightly lopsided. Could have been welded better. The rest of the stabilizers were made good. My tractor is NOT listed as these fitting. They will fit if you use your bolt on the back of the lift arm and use a 1/2" × 3" bolt instead of the one that comes with it. I used a category 0 top link from tractor supply as a shim over the front bracket so it wouldn't have any slop in it.
Daniel W
Reviewed in the United States on September 15, 2018
I lost the center portion of this stabilizer bar on kubota M5400 tractor and was able to use the same part of this stabilizer to replace it...
Harry Thomas
Reviewed in the United States on January 16, 2017
good sale
Recommended Products
$455.99
$ 99 .00 $99.00