Your cart is empty.
Your cart is empty.Model: Cutting Cutter Machine Voltage:110V 60HZ Net Weight:17.6LB (8KG) Item dimensions:about 22.5 X 14.5 X 30CM Standard Package: 1 x DrillIng Machine 1x US power cord , 1 x Full Accessories Set(1pc 3mm cutter, 1pc 2.0-3.0mm center drill, 1pc 1.5-2.5mm guide pin, 1pc 2.0-3.0mm guide pin
jim larue motors
Reviewed in the United States on May 15, 2025
JUNK would not cut a key that would work correctly isn't true on alighnment you get what you pay for
Colton
Reviewed in the United States on May 11, 2025
Showed up in a week made my frist key takes some learning
Cyrus S.
Reviewed in the United States on August 29, 2024
Delivered early. I haven't used it yet.
Gerardo
Reviewed in the United States on July 19, 2024
Llego súper adelantado me dieron fecha de entrega como para un mes y en menos de 8 días estaba ya en mi casa muy biueda las protecciones se ve que cuidan sus envíos era un regalo para mi sobrino y se puso muy contento con su nueva máquina. Si hay que reforzar las mordazas con un tornillo pero creo que en todas estas máquinas es igual sea de la marca que sea y no es algo difícil de hacer, está la envié a Cuba si llega a su destino compraré otra más
Julismar Santana
Reviewed in the United States on May 25, 2024
Working Good for me 👍
Daryl Glenn
Reviewed in the United States on November 20, 2024
There's really no intelligible instructions for this device.
Rhodes Autos Inc.
Reviewed in the United States on April 8, 2024
It does exactly what it says it does.It has saved me thousands on locksmiths.I use it for automotive keys! 🔑
James
Reviewed in the United States on April 22, 2024
The biggest problem with this machine is the clamps that hold the key & the key blank, especially the blank. I have read that some people buy a different brand of clamp and install it. I didn't want to do that. I drilled & tapped some holes to allow me to use button head screws to hold the blanks & keys down. The steel cut like butter. It's probably 12L14 or something similar. Without the added screws, the cutter sometimes sucks the blank out of the clamp & then the blank becomes damaged & never clamps right again. It would really be better to remachine the blocks with a deeper grip & a retaining ledge, but adding screws is cheaper, faster, and easier. You also have to watch the tightness of the table travel. The spindle itself works well. The cutter is OK. The tracing pin may be just slightly oversized. The two key clamp blocks were out of line with the spindle spacing by about 0.005", or about the thickness of a piece of paper. They are adjustable. After adding the screws, I was able to make workable HU66 key copies for a VW, but they were not perfect.
Recommended Products
$416.98
$ 99 .00 $99.00