Shopping Cart

Your cart is empty.

Your cart is empty.

CV Axle Boot Clamp Tool, Sturdy CV Boot Clamp Pliers, Alloy Steel CV Joint Drive Shaft Clamping Tool, CV Axle Installation and Removal Tool, Single Ear Hose Clamp Tool for Most Cars

4.9 (2) Write Review
Free shipping on orders over $29.99

$15.98

$ 7 .99 $7.99

In Stock

About this item

  • Premium Alloy Steel: Our CV axle boot clamp tool is made of high-hardness alloy steel, sturdy and enduring. Its screw strength is 10.9 grade. Suitable for replacing damaged drive shaft CV boot clamps for automobiles
  • Size Details: The jaw opening of the plier can be adjusted freely, and the maximum opening length can reach 20 mm/0.78 inches by rotating the 13 mm/0.5-inch screw
  • Easy to Use: Crimp the clamp, then turn the screw to lock the crimp in place for easy removal
  • Practical Tool: Our CV boot clamp plier is used to close the locking band of single-ear hose clamps and earless clamps. It is specially used to remove and install locking straps on automotive boots
  • Widely Uses: This tool is suitable for locking straps on shaft boots. Its size and structure match most single-ear hose clamps
  • After-sales: If you have any questions, please get in touch with us, our service team will provide you with a professional and satisfactory service


This CV axle boot clamp tool is designed to remove and install the locking strap on the car boot. It is made of premium alloy steel, which is strong and enduring, oil-resistant,, and high-temperature resistant. Its size and structure match most single-ear hose clamps.

Feature:

Easy Installation: This CV axle boot clamp tool makes it easy to remove and installation of locking straps on automotive boots.

Enduring: Our drive shaft clamping tool is enduring and high-temperature resistant. It is used to replace damaged drive shaft CV boot clamps on automobiles.

Parts List:

1×CV Axle Boot Clamp Tool

Specification:

Product Name: CV Axle Boot Clamp Tool

Product Material: Alloy Steel

Product Size: 11×2.1×2.6 cm(4.33×0.83×1.02 inches)

Color: Black

Notes:

1. There may be slight differences between the picture and the actual color of the commodity. We will try our best to show you the exact color.

2. Please allow slight dimension differences due to manual measurement.


Daniel Edwards
Reviewed in the United States on April 12, 2025
This is a little awkward to use in tight spaces because you have to get a wrench/or ratchet in there tighten your band clamp, as opposed to the purposely made wrench that does the same thing. I guess it depends on your situation as to which tool, this or the pliers are better for the job. This definitely worked but on the outside boot of the CV joint, it's a little cumbersome to get on, again this is vehicle dependent the vehicle you are working on so maybe it was just a little bit of a pain with the Subaru Forester I was working on. At the same time I only used it one time so far and one vehicle and it did do the job and it's made pretty well and cheaply priced so I would definitely say it's worth it. This is a tool that won't get used much by the DIY shade tree mechanic, but it's good to have on hand.
clund76
Reviewed in the United States on April 10, 2025
Seems pretty decent build. My intention is to use this for center slip yoke drive shaft cover(style with carrier bearings) to the install clamps.Time will tell if this holds up