Shopping Cart

Your cart is empty.

Your cart is empty.

Emgo Muffler Reducer 80-47310

4.9 (8) Write Review
Free shipping on orders over $29.99

$11.67

$ 5 .99 $5.99

In Stock
  • Sold on Amazon


DescriptionThree-piece set gives any 13/4 i.d. muffler a perfect fit over three sizes of pipesReduces 13/4 to 15/8, 11/2 or 13/8


CONCERNED AND UPSET BUYER
Reviewed in the United States on April 15, 2025
does not work
Ron
Reviewed in the United States on July 14, 2024
They could have been made narrower but otherwise worked fine.
Ron
Reviewed in the United States on May 16, 2019
The package arrived fast and once I selected the correct one I needed from it, fitment was excellent! Very easy to use and works very well.
Jimmy D. Duran
Reviewed in the United States on October 5, 2019
Didn’t work for me but wasn’t the products fault. It just wasn’t designed for my application. It’s a great design though. I’d recommend it. See the product review and others on my YouTube channel the real fade show.
Jeff S.
Reviewed in the United States on April 30, 2019
The part worked great to fit my new slip on exhaust pipes they are 3 different sized sections that reduce down in size. you can use all three , two or just one depending on the reduction of size that is required. great product.
SuperD952
Reviewed in the United States on June 27, 2016
I bought this to connect my motorcycle header pipe of 1 3/8" to a 1 5/8" muffler. I had to cut the reducer to make it fit into the opening on the muffler. I made it work with modification.
Dylan P.
Reviewed in the United States on June 24, 2016
I bough these to use to adapt some OEM harley pipes to my Kawasaki to lower the exhaust noise. I never ended up installing them because I sold the bike, but the quality appears good and I had no complaints. The only worry I'd have would be leaks, so I'd probably recommend using some exhaust paste to install these to reduce the chances of leaks.
Jeremy
Reviewed in the United States on July 30, 2012
Ordered these to go between my new mufflers and the existing 1 3/8" header pipe on my 1970 CB175. The smallest reducer is supposed to be 1 3/8 ID, but when fully compressed, it's a bit larger than that, which doesn't allow you to clamp it fully onto the pipe. I had to compress it fully, then pop one edge over the other for it to fit tightly, followed by a bit of wrapping at the junction between the two pipes to prevent exhaust leaks. So, yes, it can be made to work, but just be warned that it might not fit perfectly on 1 3/8 pipes.