Your cart is empty.
Your cart is empty.Value-priced, high quality tools - leading the market by ensuring that products are rugged, reliable and reasonably priced.
Josh Hettrick
Reviewed in the United States on October 1, 2024
Item pictured shows a stepped die to measure how far the brake line is supposed to come up in the tool to get a good flare. The item received is a solid die. I could have gotten the same one way cheaper if I wanted this solid pos. I specifically paid more for the stepped bit and did not receive it.
H.M.A.
Reviewed in Australia on June 5, 2023
Just the adapter required for making a double lap 3/16 flare in brake pipe-No problems setting up with flaring tool.
Robert Conklin
Reviewed in the United States on May 3, 2023
It is different than pictured.But it does the job
Jay Dee
Reviewed in the United States on May 16, 2021
With pin facing up, the first step on the edge is the gauge to set the right height for the end of your line (before flaring)above the flaring tool when double flaring. I found just a hair more worked better for me using nickel/copper lines ( I used 4Lifetime Lines). If you have lines tight enough in the die + it get a tiny crush line on the edge of tube + flare after finishing, just carefully file it off after flaring. Saves to buy this ala-carte to add to your kit than to buy a whole set, if you don't flare anything but 3/8ths lines. Vendor was a little slow, but I wasn't in a hurry+tool was satisfactory. Watch a you tube video on double flaring if you don't understand. A must have for those times your rusty old lines are problematic + need replaced. It ain't Rocket Science.
Joe H.
Reviewed in the United States on February 11, 2021
Seemed to fit fine, unfortunately I was using a cheap multi slot flaring tooled that gouged sides of tubing rendering tubing useless.
andre berlinguette
Reviewed in Canada on January 2, 2021
Works well
Gary B
Reviewed in the United States on September 20, 2020
I broke the original flaring tool, and bought this one as a replacement. 3/16" is the most common size used in autos. Being the center stud is small, it is prone to breakage if not careful. This one works fine.
Rejean Desrosiers
Reviewed in Canada on August 18, 2020
Excellent achat
Rene
Reviewed in Canada on June 2, 2020
Bought as spares for my flaring tool set .
Customer
Reviewed in Canada on October 23, 2020
Arrived quickly unfortunately the first one broke perhaps not the fault of the tool. Ordered a second one which again arrived very quickly but at twice the price of the first one
jose guzman
Reviewed in the United States on July 9, 2019
it works but it breaks
Rod Mac
Reviewed in the United States on April 2, 2018
Part looks good. Broke my last one from a kit (not this brand) on a bubble flare not a double flare as this part is for. Happy to get a good guality replacement as 3/16 is a very common size
JoeTech
Reviewed in the United States on October 29, 2011
Received this flare adapter, after having broken the original one and was unable to finish making the rest of the brake lines I needed.This replacement was good quality and held up to make six more line flares.I found it works best when you chamfer the brake line and use either brake fluid or penetrating oil so that the flare adapter won't break and is also able to come out of the end of the finished flare.
Recommended Products
$87.12
$ 39 .99 $39.99