Your cart is empty.
Your cart is empty.Product Description
Specifications:
- Material: Metal + Rubber
- Color: Army green
- Size: - Total Length:38cm - Rubber Nozzle Length: 12cm - Spout Diameter: 2cm - Nozzle end Diameter: 1.2cm.
Ergonomic Design
The ergonomic handle and nozzle grip offer comfort and convenience during use
Easy Installation
Remove your existing jerry can spout.Insert the flexible Long Nose into the can's opening.
Rubber gaskets
Thickened sealing rubber rings are used at the joint,tighten it securely to to ensure no oil leakage
Norman H. Opolsky
Reviewed in the United States on March 8, 2025
Gasket doesn't stay in place. Doesn't form a tight seal to the can and leaks a lot.I'm using Wavian NATO cans.
Donald L. Colburn
Reviewed in the United States on September 12, 2024
fast shipping
RPB
Reviewed in the United States on August 4, 2024
This spout works BUT would be nice if it had a cap to close it between uses.changing this to the cap that came with the can each time you use it is fine ifyou are moving it in a truck ... but storing it in the shed and filling a mower every few hours,can be a pain closing it each time.
Chopper
Reviewed in the United States on July 24, 2024
Wish it would have a cap to prevent evaporation when storing in my garage.
Anonymous
Reviewed in the United States on May 26, 2024
These fit my authentic SMALL MOUTH NATO cans I purchased from Coleman's surplus.They come with a gasket already, which I permanately affixed with some 2-sided foam tape.
Terrapin Overland
Reviewed in the United States on December 17, 2024
I have a wavian Jerry can. This does not fit.
Gailand
Reviewed in the United States on September 7, 2023
I had purchased these for my well built red and yellow fuel cans. The effort put into manufacturing these fell far short of the quality of the cans. I had expected a suction vent to aid in the ease of pouring, but I had not expected them to have a hole through which to leak right from the spout all over the place.The rubber seal fell out almost as fast as I was able to remove it from the packaging. The surface where a seal was supposed to be achieved had multiple bumps in it which would have made achieving said seal a challenge. They are too much of a hazard to try to use.
Randy Aldridge
Reviewed in the United States on November 19, 2023
Need one for my Ural factory can fits tight like it should
Recommended Products