Shopping Cart

Your cart is empty.

Your cart is empty.

For VLT-XD600LP Replacement projector lamp for Mitsubishi FD630U WD620U XD600U by Mogobe

Free shipping on orders over $29.99

$58.90

$ 29 .99 $29.99

In Stock

About this item

  • Mogobe Compatible projector lamp for Mitsubishi FD630U WD620U XD600U - Projector Lamp - 2000 Hour - VLT-XD600LP-ER
  • Mogobe Brand New High quality Lamp! 6 Months Warranty!
  • Mogobe is responsible for all the item descriptions and warranty.



Product Description

How to replace the lamp:

  • Turn on the projector and unplug the power cord.
  • Wait one hour to allow it to cool thoroughly.(Caution: Do not remove the lamp unit from the projector right after use. The lamp will be hot and may cause burn injury.
  • Turn the projector over. Open the lamp unit cover by loosening the screws with screwdriver.
  • Loosen the securing screws on the lamp with screwdriver. Hold the lamp unit well and put it out from the direction of the arrow.
  • Insert the new lamp until it’s securely in place. Tighten the screws. Fold the handle.
  • Connect the lamp connector and tighten the screws.
  • Close the lamp cover and tighten the screws.
  • Reset the Projector by following the Projector Operating Manual.

How can I contact Seller:

Click Orders in in the upper-right corner, find your order in the list, and click Get help with order.

How can I get a refund:

  • Go to Your Orders.
  • Locate your order in the list and click Problem with order.
  • Select your problem from the list.
  • Select Request refund.
  • Enter your comments in the text box.
  • Select Submit.

Teresa Propst
Reviewed in the United States on September 16, 2021
Ordered this part for our church projector but unfortunately our projector it toast. So we never had a chance to use the replacement bulb. The original cost was refunded quickly!
Chris B.
Reviewed in the United States on July 23, 2018
This lamp does appear to be an exact replacement for the original bulb (they were visibly identical, down to the markings), and installed without any issues (though it should be noted the bulb is held in by a single screw that is not obvious in the install instructions).I'm currently running the bulb with the projector in "Eco mode" and I'm very happy with the brightness and image quality (standard mode doesn't offer much of a brightness improvement so I opted for the longer-life option). I'll update this review if it burns out before it's expected lifespan.
Daniel Glownia
Reviewed in the United States on November 4, 2018
I bought this product and it was defective. I installed in on my projector according to the manufacturers instructions however when projector turns on, the light flickers and turns off. Is there anyone that could help me with this? Perhaps I am missing an additional step.
Customer
Reviewed in the United States on October 21, 2018
It is bright, but flickers when adjusting or scrolling through projector menu.
Anthony C.
Reviewed in the United States on January 30, 2018
This is my main screen for my house. This bulb has been in use for 4 months with 2-3 hours per day. The housing was a tight fit and I could not screw to the housing to the projector. The bulb still worked despite this issue. The bulb is not as bright as the original, but still a bright bulb. My screen is in a living room that has 2 large windows on each side of the view area without blackout curtains on them, only thick darkening curtains. I can watch television during the day with a low to moderate wash out from the sun. Night viewing with this bulb is still very good. Missing one star due to tight fit and not being able to screw it to the projector and the slight dimness during daytime viewing compared to the original bulb.
Jon Swann
Reviewed in the United States on April 5, 2018
Shuts off after about 30 seconds. Did not work for Mitsubishi FD630U.
Recommended Products

$109.99

$ 52 .99 $52.99

4.6
Select Option