Shopping Cart

Your cart is empty.

Your cart is empty.

FPV Quadcopter Drone Operator Glove for FPV Transmitter Remote Control Transmitter Handwear RC Hobby Support for Basically All transmitters Including RaidioMaster TX16 Spektrum DX6 NX10, etc

Free shipping on orders over $29.99

$21.99

$ 10 .99 $10.99

In Stock
  • **Exceptional Thermal Insulation:** Designed for heat accumulation, these gloves offer superior warmth retention and windproof protection, allowing you to brave even the coldest of days, ensuring you stay cozy and comfortable throughout the winter months.
  • **Comfortable and Soft Touch:** The gloves offer a comfortable and soft feel, making them a pleasure to wear for both adults and children.
  • One-size-fits-all, suit for basically all remote control, With this glove on, you can easily adjust the throttle, switch channels or switch flight modes without taking off your gloves. The gloves are suitable for most types of FPV remote controllers.
  • **Extended Battery Life:** You get added benefit of preventing rapid battery drain on your remote devices with these gloves.


One-size-fits-all, suit for basically all remote control, With this glove on, you can easily adjust the throttle, switch channels or switch flight modes without taking off your gloves. The gloves are suitable for most types of FPV remote controllers.


djm
Reviewed in the United States on February 9, 2025
Product works. It lets me fly with bare hands in sub 10f to 32F temps; much better than any of the gloves I've tried. I gave 4 stars instead of 5 fro 2 reasons: 1. The plastic window can fog up if your hands are sweating at all. I was surprised when this happened. 2. it is hard to get the antenna opening side of the glove sealed up well enough to keep out cold/draft using just the velcro closures built in for that purpose. I use some extra spring loaded clips. This probably contributes to problem 1. But leaving those flaps open lets in too much cold air, making the gloves useless. DJI consumer drone users take note: I use this glove with a few different DJI drone controllers. They all have two relatively short antennas. I had hoped there would be some cutouts for these to stick outside the glove, but there are not. So far I have been flying with the antennas sealed up fully inside the glove, but I'm thinking about modifying it to let them stick out for better range (not sure it matters). This is not a product flaw, as the product photo clearly shows it being used with a single, center mounted antenna. But it is an issue for me.
Kevin Sink
Reviewed in the United States on January 6, 2025
It works. It’s a bit clumsy because it flops around your hands and controller. I imagine some of the awkwardness would decrease with practice. I built a 3 sided rectangular structure out of cardboard & Velcro straps in about 10 minutes, and it keeps the inner working environment a lot more stable.I put a couple hand warmers in there and could fly with no gloves when it was about 15 F outside.
Mr. Grinch!
Reviewed in the United States on September 19, 2024
It seems Like a good Item You have to wash it Showed up with Oil On it
Recommended Products

$127.99

$ 62 .99 $62.99

4.5
Select Option

$66.00

$ 30 .99 $30.99

4.5
Select Option