Your cart is empty.
Your cart is empty.Product Description
Denise
Reviewed in the United States on May 26, 2025
Welds broke first use with a winch and bumper nearly came off of drivers side. Welds did not penetrate bracket mounting to the bumper itself and just sheared off the plate
musman50
Reviewed in the United States on February 28, 2025
Fit was great thus far the powder coat is holding up great looks amazing lots of compliments on it for an inexpensive bumper this is well worth the money would highly recommend
Lenny
Reviewed in the United States on April 22, 2025
The bumper does fit on my 2020 Gladiator Sport and gives my Jeep the look I was going for. The install was pretty straight forward. As another reviewer stated, it took way longer to take the stock bumper off than to install this one.Why only 3 stars? 2 of the bigger reasons I purchased this bumper was because it stated the stock fog lights bolted on and there were holes for mounting a license plate (required where I live). Neither of these statements turned out to be true in my case. The fog light mounts only accept the 4 bolt pattern, not the 3 bolt pattern of the Gladiator. The supposed license plate mounting holes also do not remotely line up with a NY state license plate. I might have gone in a different direction if I had known (before I uninstalled the stock bumper and fog lights) that I would have to purchase different fog lights and a license plate bracket to make this bumper work.
Jacob Green
Reviewed in the United States on April 21, 2025
👍🏼
Alex Hernandez
Reviewed in the United States on May 20, 2024
This is an ideal setup for my Jeep since my wife and I are both veterans.
dan
Reviewed in the United States on March 19, 2024
Stubby bumper is awesome. I co tasted the manufacturer through Amazon asking if the factory fog lights worked with the OBNAUX bumper they told me that the cut outs were 105mm and they would fit. When installing it turns out there’s nowhere for the lights to fasten too. If you’re not handy I would highly recommend getting this professionally installed. I had to use tap screws and had to drill the factory fog lights in myself. Other than that it’s a great product great fit. Great product for the money. They also offer a two year manufactures warranty only downfall is if it starts to rust you gotta take everything off and send it back I’m assuming. This fits ALL 2024 WRANGLER MODELS not just the 4xe.
KC473
Reviewed in the United States on December 31, 2024
Form is good, function of holding lights and providing a little protection to the front end appear to be in check. I wouldn't pull too hard on the hoop, I'm talking pulling by hand or anything else! Hoop is held on with 8 small bolts and light duty feeling. I would be cautious of the tow tabs and winch mount too, not saying it wouldn't hold up but I have a JCR offroad mauler bumper on a JK and there is no comparison except for the "look".... If you are mall crawling and wont likely do too much winching this bumper is an awesome deal at sub $200. It delivered a week earlier than original estimate. It took longer to get the old bumper off than to install the new one. LED fog lights on 2019 JL bolted right up, did a little work to extend factory harness. I also trimmed the lip off the factory grill to bumper filler and reinstalled it, gives it a more finished look.
David Miller
Reviewed in the United States on April 17, 2024
Looks good on my jeep
Recommended Products
$93.00
$ 36 .99 $36.99