Your cart is empty.
Your cart is empty. This Purge valve is replacement for:
For US Market;
2013-2017 Range Rover Evoque L538 2.0T With Ecoboost Engine
2015-2017 Discovery Sport 2.0T With Ecoboost Engine
For UK Market:
Freelander 2 2006 - 2014
Range Rover Evoque 2012 >
Range Rover 2013 >
Range Rover Sport 2014 >
Discovery Sport 2015 >
Natalia
Reviewed in the United States on May 20, 2025
No era lo que necesitaba
Joe
Reviewed in the United States on May 27, 2024
Unfortunately the part I got was either used or defective. The o ring that the picture shows was missing so I used the one off the old valve and should have just sent it back since a mechanic tested the valve and showed it doesn't hold vacuum when not active. Unfortunately I can't return it because it's past the return date. If you order one test it before and make sure it comes with the small o ring or you will be ordering another one.
Miguel perez
Reviewed in the United States on February 7, 2024
Muy buena
digimate
Reviewed in Canada on November 8, 2024
Works well in my land rover. Taking one star off for the quality of the plastic. Seems a bit too brittle. That being said, haven't had any issues in over 50K km in driving.
Brad
Reviewed in the United States on October 7, 2024
Part worked for a few days and wasn’t functional after.
Angel
Reviewed in the United States on January 8, 2024
I’ve just installed it yesterday and so far it’s working great. I was able to put gas in my car without any problems or any hesitation so far so good
kdobes
Reviewed in the United States on August 20, 2023
Compatible with 2013 Range Rover Evoque (US spec).It will take a bit of work to get this installed because the old one is permanently installed in the hose and will need to be cut out. You'll then need to come up with a way to replace the line you cut out. This is still significantly easier and cheaper than the standard repair which requires replacement of the entire EVAP system from engine to gas tank since all the connections are permanently heat formed.To install: Cut the old solenoid out. 5/16" fuel vapor hose will fit onto the new solenoid (it will be tight), and then slip the 5/16" hose over the outside of the old hose that you cut. Add hose clamps or zip ties if you like but it seems to be a snug enough fit to not need it.
The Abrams
Reviewed in the United States on July 25, 2023
When working on a land rover in the country, it can be difficult to find euro parts. This arrived quick, and was a perfect fit.
Cliffmon
Reviewed in the United States on January 14, 2023
Easy to install and worked perfectly
Recommended Products
