Your cart is empty.
Your cart is empty. Attributes:
* Thread Size: M20 x 1
* Square Shank Width: 11mm / 0.43"
* Thread Length: 35mm / 1.38"
* Overall Length: 80mm / 3.15"
* Material: Alloy Tool Steel (9SiCr)
What Is Included:
* 1 Pair x Hand Threading Taps
Applications & Features:
--- Suitable for tapping through or shallow and blind holes. Straight flutes design, downward chip removal, clear threads without burrs, fast thread processing. Hand taps can create new female threads or re-thread damaged or jammed female threads. Used for threading aluminum, mild steel, copper, hard plastic, etc. Hand taps are used by tap wrenches. Taper taps start tapping threads at right angle to workpieces, plug taps is generally used for drilling through holes, and bottom taps create threads at the bottom of holes.
--- Alloy tool steel (9SiCr) screw taps have high hardness, high torque, good toughness and wear-resistance, good for general purpose applications. Tapping oil is lubrication, cooling and anti-sticking. Add appropriate tapping oil for higher quality internal threads and more durable taps. The tapping depth should not exceed 1.5 times the diameter (eg: diameter=6mm (M6), maximum tapping depth=9mm). Drill holes with a twist drill before tapping, and the tapping angle should be 90 degrees vertical and stable.
Useful Tips:
--- The higher the hardness, the slower the speed. Fast speed and low torque; slow speed and high torque. When tapping plastic, add lubricating coolant. For steel, motor oil is generally used, and vegetable oil is used for high requirements. Apply anti-rust oil for maintenance after use to prolong the service life.
Clark H.
Reviewed in Canada on March 4, 2024
The product arrived promptly and in good condition. I used it to clear the rust and dirt filled threads in a welded on nut in the frame of my Toyota, so I could bolt on a trailer hitch using the Toyota's built in attachment points. I was afraid because I had been sent two taps that the steel might be of low quality and I might need both because they would not remain sharp. The tap cut through the rust in the four bolt holes easily and it showed no obvious signs of becoming dull to the point of being ineffective. I did not need to use the second tap. It is only because I have not used the one tap enough to truly know that it is good steel that I cannot truthfully give it five stars. But I am delighted that it did both easily and well the job for which I purchased it. If you need to put on a trailer hitch then this tap will get the job done and leave you with a second brand new tap for the next challenge. I received very good value. My thanks to the seller.
KSR
Reviewed in Canada on March 3, 2024
My use case was to clean out corroded frame nut for installation of a trailer hitch. Initially I used copious amounts of WD-40 with a plastic brush to clean. The tap was not catching the threads well and I was very concerned about destroying the bolts. I purchased a set of drill-mounted wire brushes, re-applied WD-40 and reamed with the various brushed. Once this step was done, the taps performed flawlessly.
peter
Reviewed in Canada on July 22, 2023
Taps are top quality ,extremely sharp, almost as good as name brand German made taps
Paulo Botelho
Reviewed in Canada on May 5, 2023
I used it to make a new thread on the cylinder that came from the factory without a thread. It worked well and the spark plug was tight.
Albert Thalheim
Reviewed in Canada on December 12, 2023
La première filière a mordu sans effort. La filière de finition a terminé le travail tout aussi facilement. Impeccable!
Recommended Products
$16.15
$ 6 .99 $6.99
$25.99
$ 12 .99 $12.99