Your cart is empty.
Your cart is empty. Bee Adapter is a compact USB to serial adapter equipped with BEE (20pin 2.0mm) sockets. With integrated FT232RL IC, It can be used for programming or communicating with board which basic For Arduino but without USB interface,like Sniffer Nano. On the other hand, you may connect your PC to various wireless applications via the BEE compatible modules.
The Adapter also could support XBee interface.
Specification:
3.3V and 5V dual power output
3.3V and 5V IO compatible
USB 2.0 protocol
BitBang mode ready
Easily connected to a PC via mini USB cable
XBee-setting support software X-CTU
Usage 1: PC via a USB cable directly connected with XBee adapters
Usage 2: Bluetooth Bee configure or use as a data-transmission
Uses 3: For ARDUINO BOARD PRO MINI Downloader
Package Includes:
2 * HiLetgo Xbee USB Adapter
San Diego Electroincs Hobbyist
Reviewed in the United States on March 20, 2024
Board has FTDI chip and 3.3 volt PS for the Digi Module. Works great for configuring the module using Digi's XCTU. One caveat : if you're using the version of the module with the antenna connector, protect the 90 degree .1 inch header with insulating tape or the connecter can easily short it out. I caught this right away and had no problems, be forewarned!EHSD
MANOJ
Reviewed in the United States on July 5, 2023
Jeanne
Reviewed in the United States on June 20, 2023
3 of 5 units had the XBEE socket filled with solder and would not allow the chip to be plugged in.
Jazzathoth the smoothest demon prince
Reviewed in the United States on August 5, 2022
The Rx and tx pins are labeled wrong, also if you're using an xbee with sma connector it will hit the serial pins. Otherwise these work fine for me. No trouble with the USB interface, just took a bit to figure out the mislabeled pins.
Installation Technician
Reviewed in the United States on September 4, 2021
I bought 2 of these; one transmits, but doesn't receive. The other refuses to be recognized by a PC (and I've tried several PC's), and you can't update the USB drivers for it. I've used several XBee USB adapters before (from other manufacturers), but these were so inexpensive, I figured I'd give them a try. Wouldn't buy them again!
Steven
Reviewed in the United States on September 14, 2019
Looked like a good board, but to bad they're using counterfeit FTDI chips so you can't program it using ft_prog software from FTDI. For my intended use, you must be able to invert the TXD and RXD to use the board. So the 6 boards I've bought are useless.
Recommended Products
