Shopping Cart

Your cart is empty.

Your cart is empty.

iMeshbean® 4' Deep Well Submersible Pump, 1/2 HP, 220V, 60 Hz, 25 GPM, 150 Feet Head, Stainless Steel with Built-in Control Box M#03

Free shipping on orders over $29.99

$127.99

$ 52 .99 $52.99

In Stock

About this item

  • ★【Well Pump Technical Specifications】4",1/2HP, 230V/ 60Hz,1-1/4inch NPT discharge. Multi-state Impellers;This 220v water pump will fit in a 4" casing.
  • ★【Economy & Effective Submersible Water Pump】This submersible pump for deep well features 25GPM max flow & 150ft lift;Water pump comes with 33ft lengthy electric cord-allows for easy connection; built-in controlbox;built-in check vavle;built-in thermal protection
  • ★【Heavy Duty Deep Well Pump】Stainless steel body& iron discharge head ,permanent magnet motors & thermoplastic impellers -industrial grade heavy duty - guarantees high durability and long-lasting use;
  • ★【Submersible Well Pump Wide Application】This water well pump can used as irrigation pump and pressure booster pump; Perfectly convenient for use at home and for factory water supply;Well pump can be implemented in different types of wells-ash pipe wells, steel pipe wells, or soil wells;Can be used for extracting water from reservoirs, canals, rivers, open water tanks and other water lifting works
  • ★【Well Pumps with Built-in Controlbox】This deep well pump is with a built-in control box, it is for thermal protection, short-cut protection and overload protection (Installing additional check valve is recommended)


Technical Specifications:

4" deep well submersible pump, fits in the 4" well casing.

220V, 3.3 Amps, 150 feet max head, 25 gpm Max, mid intake.

Patented impeller design provides extended pump life and heavy flow under the severe circumstances.

This pump has a much longer pump life than the all-plastic-bottom-suction pump.

Solid stainless steel body with heavy duty cast iron discharge.

Industrial grade heavy duty, also good for home usage.

Built in 1/2 HP capacitor start, and thermal protection switch, for longer life and powerful start.

Built in control box. This pump DOES NOT require an external control box!

This is a 2 wire pump with 3-Wire (2 wires + ground wire)

33'/ 10M long electric cord, installation tape & electric tape kits are all included(all of our cords are connected with 110V US standard plug).

1-1/4” NPT discharge.

Heavy-duty thermoplastic impellers, diffusers, and intake screen.

Include a built in check valve.

High efficiency, hermetically sealed motor is thermally protected to prevent overheating, and uses less energy.

Submersible design eliminates the need for priming and creates quiet operation


CndyMarie
Reviewed in the United States on July 4, 2022
iMeshbean 4" Deep Well Submersible Pump, 1/2 HP, 220V, 60 Hz, 25 GPM, 150 Feet Head, Stainless Steel with Built-in Control Box M#03Sold by: Newgate--iMeshbean® I didn't want to give it any stars but I couldn't submit my review till I did....Should be -5 stars
Chip
Reviewed in the United States on November 4, 2021
Direct replacement for any 1/2hp submersible. I put a 1" hose barb on it and dropped it down 60ft, on 220v 2-wire (+ground). It comes with a 20' cord, 16 ga, hard to hold in a heat-shrink join to 12 ga well wire. Plan on adding waterproof tape. It gives me about 5gpm with a 40ft lift, feeding my 3/4 inch home pipes. After break-in, several months when it seemed to struggle to reach 50psi, it now works great at 55psi. It handled heavy silt and light sand when I flushed the well. Now water runs clear. Clarity means the pump is well balanced at the end of its teather and isn't trashing about on startup. When run continuously (watering the lawn), volume drops to 4gpm after 30 min.