Your cart is empty.
Your cart is empty.Replace your lost or broken keyless entry key fob remote with a USARemote Fob.
Fits P/N: L2C0007T, 10335582-88, 10335582
Chevy
2004-2012 Colorado
2001-2005 Venture
GMC
2004-2012 Canyon
Hummer
2006-2010 H3
2009-2010 H3T
Isuzu
2006 i-280
2007-2008 i-290
2006 i-350
2007-2008 i-370
Oldsmobile
2001-2004 Silhouette
Pontiac
2001-2005 Montana
This is a replacement aftermarket part.
SRL
Reviewed in the United States on May 8, 2025
It was relatively easy to change to the new fob.
Jennifer
Reviewed in the United States on May 28, 2025
Defective. The place were the battery terminal goes isn't cut out of the plastic so there's more way to install it. The first photo is the new cover and the 2nd photo is my old cover for comparison of where the terminal should go.
Bob Stover
Reviewed in the United States on May 22, 2025
Was easy to switch over!
Steve J
Reviewed in Canada on February 3, 2025
Only bought it for the rubber/silicone buttons which fitted exactly right, much less expensive then the dealership
JOSAN
Reviewed in the United States on January 5, 2025
Perfect, I was confused at first on how to put the battery clip in the case but one I looked at the key fob cover I replaced I seen how the clip needs to go in and when I positioned it right, I just pressed down both sides until it went in there, no need to make a little cut for it. Works perfect and I used my original button from the other key fob cover and it makes the buttons stick out a little bit more, which I like. Thanks
Fara
Reviewed in Canada on January 29, 2025
works well (Hummer H3)
J. Derr
Reviewed in the United States on April 16, 2025
I bought this to repair the fob for a friend. The quality was good. Assembly with swapping out the original circuit board was straight forward. He liked so well he wanted his spare remote done too.
DL-Hmmmm
Reviewed in the United States on April 13, 2025
Great product
Cliente
Reviewed in Mexico on May 5, 2024
Quedó excelente
Bryan
Reviewed in the United States on December 18, 2024
Came fast and my old fob internals transferred easily. Battery clip was present but the slots that held it in place inside the back cover were missing or uncut. After opening them up with a hot razor blade, there are notches where the slots belong, everything then went together easily and it works as expected. Taking away 1 star cause I had to mod it to work
Excelente la tela
Reviewed in Mexico on November 8, 2024
Por el costo bueno
Anynomus
Reviewed in the United States on November 22, 2024
I got this case because the ring hole snapped off my old one, so I had to carry it in my pocket and couldn't attach it to my keys. The case worked, looked nice, and had all the necessary parts. But the internal shell was too small, I spent a a few minutes trying to get the old circuit board in by force but was afraid I was going to snap it in half trying. And I tried a few different ways to get it in, from trying it with the rubber button pad inside, then trying to put it in the pad, and then the pad into the case, but it still was just barely too small. I ended up using my knife to shave a bit of the internal plastic off the wall to make it fit; regardless, it was still very tight. The other problem was with the back part, the little metal where the battery touches were not properly attached, and after further inspection, that's because the slits for the arms were not cut out, again, I used my knife to cut them, so it would fit. Unfortunately, the metal piece that came with the fob had the prongs too tight, so I tossed it and used the one from my old case. Overall, it works fine but be prepared to use your old parts, and don't be afraid to use a little force with it.
Alberto Salas
Reviewed in Mexico on October 19, 2023
No me gustó que de los dos controles que compre, solo uno funcionaba los botones del control.
Recommended Products
