Your cart is empty.
Your cart is empty. Full Size
Full Resistance: 500k ohm
Shaft Length: 18mm
Shaft Diameter: 6mm
Whole Length: 43mm
Base Diameter: 16mm
Knurled and split shaft
william huelsenkamp
Reviewed in the United States on February 19, 2025
Perfect!...Thanks much!
Wojciech Blazejewski
Reviewed in Sweden on November 6, 2024
Tack.
Private Name
Reviewed in the United States on October 15, 2024
its a simple push pull pot, i havent had issues with it
Rev M.
Reviewed in the United States on September 22, 2023
The size of the pots are great. They are very easy to use and they have great performance. The sound quality is as good as the next one. It’s a very good pot. The push pull switch for coil splitting is very good. The movement of the pots has a nice touch. I’m very pleased with how they work and I bought both the 250 and 500 ohm pots for any type guitars that I choose to use coil splitting.
Jason Seymour
Reviewed in the United Kingdom on March 3, 2023
Well they’re in and they work but I think because of the small pots there’s not to much variation of tone, it’s pretty much either muddy or clear and not a lot in between, but fortunately I can live with that the other guitarists in my band couldn’t.
MrlopezBrew
Reviewed in the United States on April 12, 2022
I got these thinking I’d get more bang for my buck over the CTS DPDT pots when I only needed one anyways. Wish I went with the CTS.The slugs on the DPDT are super tiny, just big enough to get my humbuckers 28awg wires into, but connecting two wires to one slug, might as well not have a hole at all. Not the biggest issue, I’m just no pro at soldering and it was not as easy breezy as the standard size lugs on pots.The pot is mini, not the biggest deal, but there is not a lot of space to ground on the pot, I wasn’t sure if I needed to ground the pot to the dpdt portion, did it anyways.And then last complaint is the lugs on the pot portion are super lightweight. After soldering a capacitor onto a lug, I would attempt to position the capacitor, but the slug would bend and move rather than the capacitors thin wire. I had to use needle nose pliers to keep the slugs in place when moving wires around, again, not a huge deal but if the material is that lightweight and malleable, the internal materials are probably no better.These are worth it for the price and work as they should, just know they have little issues that make soldering a bit more involved and tedious.If I ever need another dpdt pot, I’ll go for the CTS.
Esther Mendez
Reviewed in the United States on February 19, 2021
I bought these push pull pots for a bass and a guitar. They worked great. They serve their purpose of splitting the humbuckers installed in both instruments. No faulty turning, and well built. Would definitely buy again, they are a great value for the money.
niteman131
Reviewed in the United States on December 7, 2021
I haven't installed these Push / Pull pots in my guitar yet, but the initial measurements and feel look very good.They both measure above 500k (513k and 534k), which is great, as they won't load down my Humbuckers. The shaft turns very smoothly, but it's not too loose.I will be using the switches, one for coil cut and one for phase switching, on my 4 wire Humbuckers. The switches have very low on resistance, basically the same as shorting my DMM leads together !I also really like the ground lug at the back of the switch...it has essentially zero resistance to the case of the pot. So I can tie all of my grounds to the ground lug(s). This eliminates the need to solder grounds to the back of the pot casing (and I have ruined a few pots in the past due to how much heat it takes to get solder to flow on the case of the pot).The low cost of these pots has me a little worried about their reliability, but if there is no noise or scratchiness (time will tell), I think I will be a satisfied customer !
Cliente
Reviewed in Italy on October 29, 2021
Ottimo prodotto anche considerando il prezzo davvero basso. Seguendo gli schemi elettrici facilmente reperibili su internet, lavorano egregiamente su Humbucher splittabili
Zheythan Black
Reviewed in Mexico on October 19, 2021
Llego perfectamente y funciona excelente ninguna queja! Volvería comprar!
Dptss
Reviewed in Spain on March 10, 2020
Aún no los he montadso pero el tacto es bueno
curtis mcgurtis
Reviewed in the United States on June 24, 2018
I like to use linear pots for volume, and these are push/pull, so I split to single coils with my SD 59 humbuckers, splitting to the slugs in the bridge gets closer to the neck or farther from the bridge giving a warmer sweeter bridge tone, and splitting to the screws for a nice single coilish bell-like neck tone, then middle position with both split is a really excellent tone too, the linear pot sweep allows for more fine-tuning, it's a good product and ships pretty fast
Dave Erving
Reviewed in the United States on January 12, 2016
They fit well in my guitar, the only thing I can think of to improve them is, if the 6 connect points had bigger holes.Other than that they wor fine.
Recommended Products
$13.24
$ 6 .99 $6.99