Your cart is empty.
Your cart is empty.The Newpowa Universal NPB-UZ Kit consists of 4x Z' brackets and hardware ideal to mount any panel to flat surfaces such as RV/Caravan/Boat roof tops, sheds, garages, small structures etc.
cil
Reviewed in the United States on January 28, 2025
Thicker than most. Good for reverse offset if needed.
Ledow
Reviewed in the United Kingdom on April 23, 2025
These fitted well between my panels and my home-made rails on my little homebrew solar setup.Was able to easily tweak them out so I could access the nuts in the future from the sides of the panel and they fastened well and were reassuringly strong as I live in a windy area.Came with enough holes and flexibility to match them to the panel the holes I had available (with some extra washers) and held tight.Reasonably priced compared to others I've used, and did the job well, and don't appear to be weathering prematurely.
Neil Cook
Reviewed in the United Kingdom on April 2, 2025
These work very well at holding my solar panels in my garden to a Rail, Easy to fit with little effort and hold the small solar panel very well. Comes with all fittings too.
Customer
Reviewed in the United States on April 1, 2025
These are very nice mounts. Great they are adjustable to the slope of the roof and easier to adjust or remove panel if needed.
Jamie
Reviewed in the United States on September 25, 2024
Was looking for Z brackets to hang house shutters I made from fence boards. These worked perfectly. I did not want to drill holes in the brick or mortar since the house is 57 years old. Sturdy and easily mounted. Used decorative iron screws to mount them to the fascia board. I was pleased with the finished look.
Wayne Esposito
Reviewed in the United States on December 28, 2024
I like the fact that these mounting brackets are adjustable allowing for horizontal installation on a curved rv roof and allow you to remove your panel if needed. Also the are 30% cheaper than Renogy brackets.
Bruce S.
Reviewed in the United States on November 16, 2024
The bracket itself was great. To make the job easier, I attached them to the solar panel on the ground.I am really happy with this set, but the screws to attach to my roof seemed a bit short. They may have been fine, but I was not comfortable using them give the thickness of my architectural shingles, so I purchased some that were longer. I also added a strip of butyl tape to insure a watertight seal. Perhaps this is me being a bit over cautious.
d robertson
Reviewed in the United States on August 22, 2023
Wanted a solar panel mount on my RV roof other than the standard low brackets; wanted my panel up higher and also be able to remove the panel without ripping out the roof mount screws. This mount does both. Note this mount isnt JUST for curved surfaces- it can be used on flat surfaces, which I have. Just adjust the brackets all the way to most compressed. This set is half price of other products.All is well made; brackets aluminum, all hardware stainless steal. I ordered 2 of these to mount my Renogy 200W 65 inch long panel; 1 bracket up front on the short side, and 3 brackets each long 65 inch side. I drilled my own holes in the Renogy panel frame to line up the brackets with the "studs" or whatever on my RV roof.I used the provided screws to mount into the studs, but did use other larger thread 3/4 inch long screws to screw into my 3/8 inch OSB. Dont feel the provided screws had enough grip for the OSB.Recommend these brackets for RV panel install.
computergeek
Reviewed in the United States on December 12, 2023
Pros: Very sturdy, built to last. Wide range of mounting positions. Comes with everything to attach the brackets to your panels, and attach your panels to whatever support system you choose.Cons: It's a little tricky to get the nuts started on the bolts if you want the bolt heads outwards because there isn't much room to maneuver the nut and washer inside the panel's frame.Tips: Take your time and be sure to do the assembly with the panel face down on a stable flat surface covered with something soft such as a towel (to protect the solar panel surface) at a convenient height so you can't lose any nuts or washers. Once all the nuts and bolts are loosely connected, use two wrenches to tighten them.
Paul
Reviewed in Canada on October 26, 2023
These brackets are designed to accept 4 scews the holes are pre drilled so obviously the plan is for installing securely with FOUR screws. They are for a roof on a motorhome, obviously it travels down the highway and there is plenty of force hense the four screw planning.The company only shipped me enough for 2 screws per mount half of what the design requiered. I contact this company and after several comminications they said they would ship the screws required.Never heard from them again and never received anything. I was doing this instal in a very remote location where I was camping and had more expence to go purchase these screws they promised than than initial cost of the product which I will ad here they were over priced by more thank double the going rate. Renogy was out of stock and these people know this when they price their products onl Amazon.I am getting fed up with these companies promoting their products with no customer support, another reason why it getting time to buy locally as Amazon seems to not have the customer service they did in their early stages. Time to shop more local.
Robert S.
Reviewed in the United States on October 4, 2022
Good sturdy aluminum brackets, makes mounting a breeze. However, the bolts connecting the brackets to the panel are too long to fit in from under side , as shown in instructions, and putting the washer, lock washer and nut on with fat fingers was a pain. Had to use needle nose pliers to get everything started. This is only reason I can’t give it 5 ⭐️
Bryan A.
Reviewed in Canada on September 9, 2021
Very versatile mounting brackets, sturdy and look great too.
Recommended Products
