Your cart is empty.
Your cart is empty.C-spanner wrench allows you to adjust spring preload. For Ohlins shocks that do not have hydraulic preload adjusters.
Ross B
Reviewed in the United States on May 23, 2024
spanners worked great easy buy
Tim Roach
Reviewed in the United States on October 23, 2024
This does not fit a Ducati Supersport 950s Ohlins rear shock. Close but too small. You can use in a pinch one direction.
Tim Young
Reviewed in the United States on July 14, 2023
It fits perfectly to the rear shock preload adjusting ring on my Monster 937 SP. It allows you to go either way with the adjuster due to the way the wrench is set up and keeps you from marring the aluminum due to an ill fitting tool. You can still mar up your shock adjuster but only if you are not making sure you are on the ring properly. This is a must buy!
Diabolic
Reviewed in the United States on December 22, 2023
Fit and works wonderful on my rear shock on my Diavel 1260s rear shock. Also you can only make little turns at a time It's still fit so I can get my preload adjusted for me.
brett guldemond
Reviewed in the United States on October 15, 2023
Yup, a punch and hammer works better. Does not fit either nut on the Ohlins fitted on my Daytona 955.Its not a question of accessing the nut (It is buried on this bike) its that its not stamped to fit.Its got a "Ohlins" logo stamped on the bare steel handle, but I'm doubtful.Im sure the image they used is not what I got sent as well, this thing is 6.5" long, not very useful even if it did fit.
David Wilhite
Reviewed in the United States on December 23, 2021
Used it to adjust the shock on my motorcycle. It’s simple and gets the job done.It doesn’t fit perfectly for my shock but easy enough to work around that.
Chris
Reviewed in the United States on May 8, 2017
I used this on my Ducati 1199 to adjust the rear spring preload. It would be even easier if I had bought two, but the job can be done with a little patience and 1 spanner wrench. It grips the adjuster perfectly and I have had no problems with slipping or torquing the nuts down hard.
Taco
Reviewed in the United States on April 28, 2012
I made my own wrench but the hook was to thick so I had to order one. This wrench works great at makes for speedy pre load adjustments. There are two teeth. One on each end of the opening. Theoretically you can use the end teeth to spin it one way and the other tooth to spin it the other way without flipping the wrench around. It does work but I don't really see any use for it in particular.Fits my 2007 Triumph Daytona 675
Recommended Products
