Your cart is empty.
Your cart is empty.Product Description
Fredy Acosta
Reviewed in the United States on September 30, 2024
These things are freaken awesome!!! I'm very pleased with my purchase. Makes holding parallels not be a pain! They stay in place!
Milan
Reviewed in the United States on July 29, 2023
Early delivery and product works as described.
kurtis wolf
Reviewed in the United States on October 15, 2023
Have had this product for 6months and it has done its job well
Todd Linder
Reviewed in the United States on October 14, 2023
Expensive but needed in any production machine shop.
Tom English
Reviewed in the United States on December 24, 2022
This works great in 6 inch vice!!! Wish they made one for 8 inch vise but look forward to buying more edge technology products
Hawks Fan 77
Reviewed in the United States on November 28, 2021
Pretty nicely made piece for the money. I have a few Edge products at this point and have been more than pleased with their quality and attention to detail. The product was shipped super fast despite it not being listed as a Prime option.
Sorin nenu
Reviewed in the United States on June 29, 2020
Great parallel separator. No more using springs, rubber bands or bent pieces of saw blades. Good quality and about half price if what Kurt wants for them. I have seen someone posting that they can make them for less and I say good luck with that. You can do it if your time isn’t worth anything to to you. Since I have two buses, I purchased a second pair and can’t wait to get it.
D. Michael McIntyre
Reviewed in the United States on February 24, 2018
Parallels are awesome, but they fall over really easily. If you have to perform the same operation on multiple pieces, you have to clean out all the chips meticulously and set everything back up between jobs. I was constantly pulling my setup apart, brushing it out, tapping it all back together, and even then I spoiled more than one job by allowing a parallel to slip out of position in some small way.Life is better with this parallel separator. I can do one clean setup, and it stays clean no matter how many jobs I do. The black metal bits that actually hold the parallels have a slight amount of flex, but they are rigid enough to do the job. The springs are stout enough to hold the parallels firmly, but not so stout that you have to use the vise to compress them. It has every appearance of being built to last. It even works just fine in a 5" vise.
Recommended Products