Your cart is empty.
Your cart is empty.PVC Deburring Tool Inner-Outer 2 in 1 PVC Chamfer Tool, Pipe Deburring Reamer Plumbing Tool for ID 0.75" to 3.5" ,OD 0.92" to 3.89" Compatible with PVC, CPVC, ABS, PP, PE Pipe
John P. Epperson Jr.
Reviewed in the United States on March 16, 2025
Bad experience with the one sent to me. On its 1st use, the blades flew off, one never to be seen again. The glue that attached the drive shaft to the conical body didn’t attach anything and allows the shaft to move freely. I wouldn’t recommend.
cory
Reviewed in the United States on March 15, 2025
No directions, difficult to use, this product leaves a very rough finish on both 1" and 3" PVC. Difficult to secure chuck when using reaming mode. Machininig on side of tool suggests it was originally made as an automotive tool.
Jenk17
Reviewed in the United States on February 25, 2025
I did not order ninja throwing stars and honestly they might be safer!!!Item described to fit up to 3” pipe. This is true but smaller pipe is hard to bevel, bounces around and is not safe with the blades set up the way they are. I tired for both methods (bevel and ream). The blades just chew up the pipe. They are sharp but do a terrible job. The configuration is sketchy. The blades are always exposed so if use it in the beveling configuration the ‘reaming blade’ are the exposed and spinning around with no guard somewhat close to where you have to hold the pipe. A slip would be painful.I attempted 2 pieces of pipe. After the second attempt 2 of the blade flew out of the tool while spinning.
Christine Blanchard
Reviewed in the United States on June 18, 2024
This will deburr just about all DIY projects and make fitting them together a breeze.
Duke C.
Reviewed in the United States on November 29, 2024
Really rough cut
Recommended Products
