Your cart is empty.
Your cart is empty.Product Description
Frequency Selection: Long press the switch button for 5 seconds, the red light flashes 1 time to enter the frequency selection mode, and then short press the switch button to switch the frequency. Each short press switches the frequency once. The blue light flashes 1 time to indicate the frequency point 1 and the blue light flashes 2 times to indicate the frequency point 2, and in order 1/2/3/4/5/6/7/8.
Channel selection: Long press the switch button for 5 seconds, the red light flashes 2 times to enter the channel selection mode, and then short press the switch button to switch the channel. Each short press switches the channel once. The blue light flashes 1 time to indicate channel A, and the blue light flashes 2 times to indicate channel B, in order A/B/C/D/E/F.
Power Selection: Long press the switch button for 5 seconds, the red light flashes 3 times to enter the power selection mode, and then short press the switch button to switch the power. Each short press switches the power once. Blue light flashes once is 25mw, blue light flashes twice is 100mw, and blue light flashes 3 times is 200mw.
Transmit on/off setting: under normal working conditions (solid red&blue light), press the button twice quickly to switch to the transmission mode. When the red light is solid, the blue light is off representing it enters PitMode(low power debugging mode), when the red and blue light is solid means that it transmits properly. The transmitter distance of PitMode is 40~80 inches.
Save mode: After all the parameters are set, long press the switch button, and the solid red&blue lights represent the FPV camera entering the saving mode, and then the working state, otherwise the module can not exit the setup state nor save the setup parameters.
Note:
1. *The default power of the FPV camera is 25mW. For longer transmitting distance, it is recommended to adjust the camera power before use.
2. Please leave space for the flow of wind when installing the camera to ensure heat dissipation; otherwise, the overheating protection will reduce the transmit power or even shut down the transmission when it is activated.
3. It is recommended to screw on the antenna before powering on the module to extend its service life.
Andymacc
Reviewed in the United States on August 5, 2024
Pay for what you get
Recommended Products