Your cart is empty.
Your cart is empty.Shimano replacement brake hoods for the perfect fit. Specifically designed to fit ST-5700.
Joe Cruz
Reviewed in the United States on February 2, 2025
Worked just great.
Yannick T.
Reviewed in Canada on September 10, 2024
Perfect fit, easy to install.
Chun Fong
Reviewed in the United States on June 29, 2024
Perfect fit and replacement for a 10 yr old shifter hood, and arrived overnight!!
I. Gana
Reviewed in the United States on December 21, 2024
Fits well.
David S
Reviewed in the United States on October 21, 2024
I wish I had replaced my originals sooner. My 2013 road bike has been babied since I bought it new. The hood were starting to get gummy and these puppies were an exact match. Installation was fairly easy after watching a few YouTube videos. I couldn't be happier, feels like new again.
Alain
Reviewed in the United States on April 25, 2024
It is an original Shimano product, which I initially questioned because of the listing. Excellent quality
Paul
Reviewed in the United States on March 12, 2023
Fits perfectly, and easy to install. There's no reason to ride with worn out brake hoods.
Rafa Quiroz
Reviewed in Mexico on November 26, 2023
Articulo Nuevo y Original, de muy buena calidad. Desafortunadamente no es el modelo correcto para mi bici, al parecer hay muchos modelos similares, casi iguales. Me gustaría recibir asesoría del vendedor para encontrar el correcto.
Sergio
Reviewed in Australia on February 22, 2020
Good
Kindle Customer
Reviewed in Canada on October 22, 2020
Item arrived on time, and was as described. I actually needed the 5800s as the shape is different. Not the sellers fault, so I would definitely buy from them again.
MmMm
Reviewed in the United States on January 7, 2020
Super bien... Super satisfecho como todas las cosas de shimano... Excelente producto
Gordon
Reviewed in Canada on November 13, 2019
Was able to remove them and install new ones (Without removing whole lever mechanism from handlebars) using a little bit of alcohol based hand sanitizer as lubricant. Great fit!
Mr Tantrum
Reviewed in the United States on February 22, 2015
Perfect replacement for my scratched up ones from a couple of crashes. However, be sure to buy the nameplates and also the 5mm or 10mm lever adjusting blocks for the "new" look if those are damaged from crashes also (I didn't figure this out until afterwards, and have them on order now - very simple to replace and can be done with hoods and name plates in place). While it took some muscle, it was not as hard replacing these as I thought. They are made of very tough rubber. I just used a cotton swap to coat the inside with rubbing alcohol for some lubrication, and had at it. Once in place everything fit perfectly. Note that the exterior will show some white powder stuff on them after put on, but this is typical from stressing/stretching rubber.
Recommended Products
