Your cart is empty.
Your cart is empty.rf-sprinter
Reviewed in the United States on May 8, 2025
Good quality and work well. I like these very much. Even comes with spare black plastic ends strike ends.
Caden
Reviewed in the United States on May 29, 2025
These chambered well in my gun, they work well and eject like they should and are great for training with. I love that they came with extra rubber firing pins, however the down side is if you are training outside with them the orange tipped rounds are easy to lose and there are no extras of those.
The Dude Abides
Reviewed in the United States on May 28, 2025
I ordered these .40S&W's for my G22 pistol, so I could teach my son how to use this weapon. They load into the magazines pretty easily, so that's good. But they jam up when you dry fire and eject them manually, to the point where sometimes you need to take the magazine out to eject the round. I'll say they still are better than nothing, but wish they'd work a bit more flawlessly. I compared this to an actual round it it does appear to be slightly smaller than a real one. Overall, they do work for what I ordered them for and they seem to be similar in weight to the real thing and do seem to be durable - there are replacement pads for when the firing pin wears out the pad that came with them.
Razan Alfaear
Reviewed in the United States on May 14, 2025
Very good 9mm dummy rounds
Jonny B Good
Reviewed in the United States on May 14, 2025
These safety snap caps / dummy rounds are helpful for storing your magazines as well as for training on safe handling. The caps have a similar look and feel (in terms of weight) to live rounds - they are a little bit lighter but not by a big amount - and they enable you to practice safe handling and care for your 9mm firearms.
Bruce K.
Reviewed in the United States on March 8, 2025
Don’t like these snap caps. When chambered and fired in my Browning Buckmark Camper the firing pin strike created a sharp “burr” on the opposite side of the shell lip (i.e. shell lip is too thin. Not as thick as a .22 brass shell casing). I tested this out three times and confirmed that it happens every time the firing pin hits the back of a shell. Yes, each shell has the black striker backing attached but it didn’t prevent the burr from forming. I didn’t find a mark or scratch on the breach block, but I won’t be taking any chances with these snap caps. I’ll be throwing these in the trash.
Pistol Pete
Reviewed in the United States on January 29, 2025
They are working fine in my Ruger Precision Rimfire rifle for dry firing and cycling.
Customer
Reviewed in the United States on January 12, 2025
Needed these to check the operation of the bolt on my H & R .22 bolt action rifle after cleaning and reassembly of the bolt extractors, springs and plungers. First with the bolt out. I checked to see how they fit into the front of the bolt and extractors. Fit and held in pretty good. Loaded just 3 into the magazine, pulled the trigger on the first one, then with the other 2 left in the magazine to see how they fed. I chambered and ejected them. Functioned smoothly with no jams. Left the firing pin mark on the first one as it should. Repeated this and all went well. They worked as they should in my rifle.
Recommended Products
