Shopping Cart

Your cart is empty.

Your cart is empty.

Solid State Relay Module, 1 Channel DC 5V/12V 2A SSR Module Board with Low Level Trigger(5V)

4.3 (1) Write Review
Free shipping on orders over $29.99

$5.79

$ 2 .99 $2.99

In Stock
  • ABOUT DETAILS - The rated current of 1 channel SSR module is 2A, and the voltage is DC 5V/12V(optional).
  • LOW LEVEL TRIGGER - In industrial control, called PNP trigger, negetive trigger, when the voltage between the trigger terminal and the negative pole of the power supply is 0V or close to 0V.
  • CH TERMINAL - The CH terminal is the trigger terminal of the module. When there is a trigger signal, the output switches (A, B) of the solid state relay will close. The load will be conductive.
  • WITH - With to ensure the safe use of this module. High sensitivity.
  • STABLE PERFORMANCE - Stable performance of electronic components, so that your equipment can work stably.


Product Description

1

Wiring Diagram:

1

  • The power supply must be DC, and the voltage must be consistent with the voltage of the relay.
  • When the trigger terminal of the signal has a low level trigger, the relay will be turned on, and the device will work with electricity.
Type: 1 Channel
Weight: Approx.12g/ 0.4oz
Rated current: 2A
Voltage: DC 5V/12V (Optional)

Ghost Rider
Reviewed in the United States on October 29, 2023
The item description can be confusing because it clearly says 220v in the diagram below. However, this is actually in the range of 100-250v, so that covers your standard household voltage. I do not want to go into too much detail on how to use it because dealing with this level of voltage can be dangerous. I will say that this needs to be shielded and insulated. I would monitor it to see how the components hold up under load.So far, it is switching as intended and operating consistently.