Your cart is empty.
Your cart is empty.A two-pack of our popular StripBoard-2 prototyping board! ST2 StripBoard is a prototyping circuit board with a standard long strip pattern. Tracks run the length of the board. The long tracks are convenient for power and ground rails, and for signal buses. Strips can be cut as needed to make smaller tracks and circuit pads. It has 0.1" hole spacing for DIP integrated circuits and headers and other parts. ST2 has higher quality than traditional stripboard. The holes are drilled, not punched. The base material is high-quality FR4 glass epoxy board. It has better stability and moisture resistance than boards using phenolic or SRBP (synthetic resin bonded paper), which can warp with exposure to humidity.
JKal
Reviewed in the United States on July 8, 2024
hard to find this larger size and worked well for my project.
Josh P
Reviewed in the United States on May 11, 2022
Thick which is probably a good attribute, but also makes it a little harder to snap. I ended up just using a chisel and hammer to weaken the row after the size I needed and that works pretty well. I recently purchased a cheaper brand and it’s quite a bit thinner and easier to manipulate so I guess it depends what you’re looking for…it does hold up well to soldering and the strip side I’ve had no issues.
MangoMan
Reviewed in the United States on February 25, 2022
I ran out of Veraboards and decided to give these a try. These ST2 boards are good quality. The holes are clean and the traces are wide. If you are used to Veraboards, be aware that the number of rows/cols is slightly different.
Erik Nielsen
Reviewed in the United States on March 16, 2021
Great quality product
Ponyoop41
Reviewed in the United States on January 24, 2020
Works for my purpose.
Jeff
Reviewed in the United States on January 1, 2020
These are well made stripboards, much stiffer than some others. The copper strips are firmly attached to the boards, and don't tend to lift at the ends of the strips when soldering, unlike other boards I've used. Some cleanup with a soldering wick didn't damage the copper traces at all. I did have to score the boards quite a lot to be able to snap them apart to the size I needed, and the hardness of the boards requires a pretty strong and sharp drill bit to drill standoff or mounting holes or make breaks in the copper traces. These boards absolutely do not warp, and they don't flex if you have to press something into a socket or header.These are definitely the boards I'll buy in the future.
Chuck D. Bones
Reviewed in the United States on November 29, 2018
Very good construction quality. Holes are uniform and properly aligned. I wish it didn't have the corner holes, but I'm trimming the boards down anyway, so no big deal. There are cheaper ones out there, but they are not as well made. Will buy again.
Kayleigh
Reviewed in the United States on December 4, 2016
Great stripboard for the price! None of the holes were messed up like some other stripboards i've purchased. I love these.
Recommended Products
