Shopping Cart

Your cart is empty.

Your cart is empty.

The ROP Shop | 7/8' Shaft 2800 PSI Power PRESSURE WASHER PUMP for Himore, Homelite PWV(R)27/2.3

Free shipping on orders over $29.99

$84.99

$ 38 .99 $38.99

In Stock

About this item

  • The ROP Shop replacement Vertical Pressure Washer Pump
  • Specs - Maximum Pressure: 2800 PSI. Maximum Flow: 2.3 GPM. Maximum Pump Speed: 3400 RPM. Shaft Diameter: 7/8" Shaft. 3 Bolt Pattern: 7 11/16" x 6 3/16" x 6 7/16" & 4" Center to Each Outer Hole. Maximum Water Temperature: 140° F. Inlet Connection Type: Standard Garden Hose. Outlet Tube Connection: 22mm Male. Refer to images 2 and 3 for more information
  • Includes - (1) Vertical Pressure Washer Pump with Chemical Injector, Unloader Valve, Thermal Release Valve & Outlet Tube, Hose & Keyway; comes as shown in the first image
  • This pump mounts vertical and is a rear facing (water inlets/outlets come out of the rear of the engine). Pump needs at least 5.5HP to handle PSI. Pump head can be flipped
  • Please note it is not recommended to run any pressure washer pump above its maximum PSI rating. Doing so can result in damage to the pump (not covered by warranty) and/or serious bodily injury



Product Description

Pressure Washer Pumps Compatible Brands
  • Many pumps are. However, compatible replacement options do vary depending on your pressure washer’s engine shaft diameter & engine orientation, the original pump’s bolt pattern, and your engine's horsepower.

  • Your original pump was likely a strap-style (or bow tie) pump. That style isn’t made anymore. However, you can remove the spline and use your model number to find a replacement pump that you’ll install directly onto the shaft with a keyway.

  • Our pumps do require a keyway for installation onto the engine shaft. If a keyway is pictured in the listing, it will come with one. If you need to purchase one separately, you can do so from our catalog.

  • Many of our pumps don’t require oil maintenance, but some models do need oil changes. Generally, pumps with an oil vent port will need regular oil changes. Pumps without that port are sealed units and don’t need oil changes.


Paul Y. in Texas
Reviewed in the United States on June 7, 2024
Had an "Ry***" brand pressure washer that just after the warranty ran out, the pump died. I replaced it with this one and it's perfect. I have no way to measure it, but it acts like I'm getting higher pressure/flow than I did off the original pump when it was new.
Fred DeGordon
Reviewed in the United States on June 16, 2024
This washer pump was not for an EXCELL PSI 2500 Briggs and Stratton 6.5 hp washer. tried to alter as Service instructed but could not make it work. I sent one back for being wrong and got two back that were the same as the one I returned. I will do something different. thanks...
Recommended Products