Your cart is empty.
Your cart is empty.This highly reflective, easy to use, peel and stick heat shield is easily applied to almost any surface you want to block harmful radiant heat.
Jeremy
Reviewed in the United States on October 25, 2023
This heat shield tape works like a charm and holds up very well. it does not come off like the others. the key wis in the prep, just like any sticker prduct.it keeps the heat away from the plastics.
minimama
Reviewed in the United States on May 24, 2022
Used on Weber side draft carburator heat shields on my race car. Carbs are over exhaust header. Easy to apply and trim to fit metal shields. Not raced yet, so I hope adhesive holds up.Update: Have raced several weekends, and adhesive is holding up. Would use again if needed.
B. Lewis
Reviewed in the United States on September 14, 2017
This worked great for my application! It was a little thinner than I expected, but that didn't matter too much to me.I applied it to the bottom side of a Creality CR-10 print bed. Fit perfectly with not cutting required. If anyone else is looking to do the same, be careful about the power leads on the print bed. Maybe even cover them with some kapton tape before applying this. The aluminized surface could easily short those babies out if you're not careful.Anyway, the adhesive is holding up fine so far even after being held at 60 degrees C for over 16 hours straight. I'll be sure to update this review if the adhesive starts to fail at any time.
JH
Reviewed in the United States on May 3, 2016
I did clean well before application but it does not appear that the product will stay in place for too long. I also put mechanical restraint over it which seems to be helping. It does seem to work well reflecting heat but I doubt the adhesive will hold up to the elements under the hood. It will take time before I really know how good the product is.
EsqTitling
Reviewed in the United States on March 23, 2016
I bought this for the underside of a stereo speaker which is mounted above the fireplace. It used to be a non-working Fireplace so it didn't matter, but I just got it fixed, and I noticed that when the fire is going, the speaker gets very hot. So I contacted the company (Thermo-Tec) via email and they responded immediately and recommended which exact product to use. I asked if I could paint it black to match the speaker, and they responded immediately saying that would greatly diminish the heat reflective qualities. I love a company that is knowledgeable about its products and quickly responds. It was very easy to install, and the heat from the fire does not seem to be affecting the stay-fastness of the adhesive that sticks it onto the bottom of the speaker. It seems like a very thick, dense silicone weave that is substantial enough to do the job. I'm very pleased with it and my speaker now stays cool even when the fire is going.
Leon G.
Reviewed in the United States on September 3, 2014
Worked well and stays in place with the proper surface prep. I used it on the inside of my motorcycle plastics.
Nick
Reviewed in the United States on May 26, 2014
Worked well. Wrapped exhaust. Then over wrapped it with cloth and ties. Smoked like crazy for 1 hour. But did the job.
S. Baker
Reviewed in the United States on August 15, 2011
I got this as I had a wideband O2 sensor put in, and the wire for it ran close to the exhaust manifold piping, and I didn't want it to melt on me. I cut a 2*6 inch square and wrapped it around the wire, and 3 months later it's still there and no problems.I think I got a generous amount for what I paid. I can't comment as to whether the adhesive will hold up if stuck to the chassis, but it wrapped around my wire and holds there.
Recommended Products
